Hi,
On 2019/02/19 19:11, Arnd Bergmann wrote:
On Tue, Feb 19, 2019 at 6:11 AM Sugaya, Taichi
<sugaya.taichi@xxxxxxxxxxxxx> wrote:
Hi,
Thank you for you comments.
On 2019/02/18 21:09, Arnd Bergmann wrote:
On Fri, Feb 8, 2019 at 1:28 PM Sugaya Taichi
<sugaya.taichi@xxxxxxxxxxxxx> wrote:
+
+ aliases {
+ serial1 = &uart1;
+ };
Maybe start with serial0 here? It seems unusual to start
counting at 1.
The M10V evaluation board(EVB) uses a console with uart ch1, so this
alias number is derived from the used channel one.
Therefore it is no problem to change the alias number to 0.
The alias should normally reflect whatever is printed on the board,
if there are no labels, the convention is to start with zero, regardless
of what internal uart is connected to it.
I got it.
I use a "serial0" beacause there are no labels about uart ch on M10V EVB.
Thanks,
Sugaya Taichi
Arnd
