The interrupt parent description is not needed as the parent is a parent
node with 'interrupt-controller' property.
Signed-off-by: pascal paillet <p.paillet@xxxxxx>
---
Documentation/devicetree/bindings/regulator/st,stpmic1-regulator.txt | 3 ---
1 file changed, 3 deletions(-)
diff --git a/Documentation/devicetree/bindings/regulator/st,stpmic1-regulator.txt b/Documentation/devicetree/bindings/regulator/st,stpmic1-regulator.txt
index a3f4762..de27897 100644
--- a/Documentation/devicetree/bindings/regulator/st,stpmic1-regulator.txt
+++ b/Documentation/devicetree/bindings/regulator/st,stpmic1-regulator.txt
@@ -29,7 +29,6 @@ Optional properties:
if set, all regulators are switched off in case of over-current detection
on this regulator,
if not set, the driver only sends an over-current event.
-- interrupt-parent: phandle to the parent interrupt controller
- interrupts: index of current limit detection interrupt
- <regulator>-supply: phandle to the parent supply/regulator node
each regulator supply can be described except vref_ddr.
@@ -43,7 +42,6 @@ regulators {
vdd_core: buck1 {
regulator-name = "vdd_core";
interrupts = <IT_CURLIM_BUCK1 0>;
- interrupt-parent = <&pmic>;
st,mask-reset;
regulator-pull-down;
regulator-min-microvolt = <700000>;
@@ -53,7 +51,6 @@ regulators {
v3v3: buck4 {
regulator-name = "v3v3";
interrupts = <IT_CURLIM_BUCK4 0>;
- interrupt-parent = <&mypmic>;
regulator-min-microvolt = <3300000>;
regulator-max-microvolt = <3300000>;
--
1.9.1
