On Sat, Feb 02, 2019 at 05:12:47PM +0000, Jonathan Cameron wrote:
> On Fri, 1 Feb 2019 22:57:59 +0100
> Tomasz Duszynski <tduszyns@xxxxxxxxx> wrote:
>
> > Add device tree support for Plantower PMS7003 particulate matter sensor.
> >
> > Signed-off-by: Tomasz Duszynski <tduszyns@xxxxxxxxx>
> Hi Tomasz,
>
> Sorry, I clearly didn't look at this in enough detail on earlier versions.
> I think the set gpio is rather device specific so should have a vendor
> prefix.
>
> I would also like to get an opinion on the generic name from the devicetree
> maintainers before we start to standardise on it.
>
> Thanks,
>
> Jonathan
>
> > ---
> > .../iio/chemical/plantower,pms7003.txt | 20 +++++++++++++++++++
> > 1 file changed, 20 insertions(+)
> > create mode 100644 Documentation/devicetree/bindings/iio/chemical/plantower,pms7003.txt
> >
> > diff --git a/Documentation/devicetree/bindings/iio/chemical/plantower,pms7003.txt b/Documentation/devicetree/bindings/iio/chemical/plantower,pms7003.txt
> > new file mode 100644
> > index 000000000000..cbad95480e04
> > --- /dev/null
> > +++ b/Documentation/devicetree/bindings/iio/chemical/plantower,pms7003.txt
> > @@ -0,0 +1,20 @@
> > +* Plantower PMS7003 particulate matter sensor
> > +
> > +Required properties:
> > +- compatible: must be "plantower,pms7003"
> > +- vcc-supply: phandle to the regulator that provides power to the sensor
> > +
> > +Optional properties:
> > +- set-gpios: phandle to the GPIO connected to the SET line
>
> Hmm. This is a somewhat 'unusual' one so should probably have a vendor prefix.
>
Makes sense. I'll respin the series with this extra change you're
suggesting.
> > +- reset-gpios: phandle to the GPIO connected to the RESET line
>
> reset is common and clear in meaning, so vendor prefix probably not appropriate.
> > +
> > +Refer to serial/slave-device.txt for generic serial attached device bindings.
> > +
> > +Example:
> > +
> > +&uart0 {
> > + air-pollution-sensor {
> > + vcc-supply = <®_vcc5v0>;
> > + compatible = "plantower,pms7003";
> > + };
> > +};
>
