On Wed, Jan 30, 2019 at 11:41:28AM +0000, Charles Keepax wrote: > Lochnagar is an evaluation and development board for Cirrus > Logic Smart CODEC and Amp devices. It allows the connection of > most Cirrus Logic devices on mini-cards, as well as allowing > connection of various application processor systems to provide a > full evaluation platform. This driver supports the board > controller chip on the Lochnagar board. > > Lochnagar provides many pins which can generally be used for an > audio function such as an AIF or a PDM interface, but also as > GPIOs. > > Signed-off-by: Charles Keepax <ckeepax@xxxxxxxxxxxxxxxxxxxxx> > Reviewed-by: Linus Walleij <linus.walleij@xxxxxxxxxx> > --- > > No changes since v6. > > Thanks, > Charles > > drivers/pinctrl/cirrus/Kconfig | 10 + > drivers/pinctrl/cirrus/Makefile | 2 + > drivers/pinctrl/cirrus/pinctrl-lochnagar.c | 1236 ++++++++++++++++++++++++++++ > 3 files changed, 1248 insertions(+) > create mode 100644 drivers/pinctrl/cirrus/pinctrl-lochnagar.c > > +LN2_PIN_MUX(FPGA_GPIO1, "fgpa-gpio1"); > +LN2_PIN_MUX(FPGA_GPIO2, "fgpa-gpio2"); > +LN2_PIN_MUX(FPGA_GPIO3, "fgpa-gpio3"); > +LN2_PIN_MUX(FPGA_GPIO4, "fgpa-gpio4"); > +LN2_PIN_MUX(FPGA_GPIO5, "fgpa-gpio5"); > +LN2_PIN_MUX(FPGA_GPIO6, "fgpa-gpio6"); Apologies for this late spot but there is typo here, these should of course read fpga not fgpa. I will resend, going to start sending the sub drivers separately now, since Lee has merged the MFD cut down on the email traffic for everyone a little. Thanks, Charles
