Reviewed-by: JC Kuo <jckuo@xxxxxxxxxx>
On 1/25/19 7:25 PM, Thierry Reding wrote:
From: Thierry Reding <treding@xxxxxxxxxx>
Extend the bindings to cover the set of features found in Tegra186. Note
that, technically, there are four more supplies connected to the XUSB
pad controller (DVDD_PEX, DVDD_PEX_PLL, HVDD_PEX and HVDD_PEX_PLL), but
the power sequencing requirements of Tegra186 require these to be under
the control of the PMIC.
Signed-off-by: Thierry Reding <treding@xxxxxxxxxx>
---
.../bindings/phy/nvidia,tegra124-xusb-padctl.txt | 9 +++++++++
1 file changed, 9 insertions(+)
diff --git a/Documentation/devicetree/bindings/phy/nvidia,tegra124-xusb-padctl.txt b/Documentation/devicetree/bindings/phy/nvidia,tegra124-xusb-padctl.txt
index 3742c152c467..daedb15f322e 100644
--- a/Documentation/devicetree/bindings/phy/nvidia,tegra124-xusb-padctl.txt
+++ b/Documentation/devicetree/bindings/phy/nvidia,tegra124-xusb-padctl.txt
@@ -36,11 +36,20 @@ Required properties:
- Tegra124: "nvidia,tegra124-xusb-padctl"
- Tegra132: "nvidia,tegra132-xusb-padctl", "nvidia,tegra124-xusb-padctl"
- Tegra210: "nvidia,tegra210-xusb-padctl"
+ - Tegra186: "nvidia,tegra186-xusb-padctl"
- reg: Physical base address and length of the controller's registers.
- resets: Must contain an entry for each entry in reset-names.
- reset-names: Must include the following entries:
- "padctl"
+For Tegra186:
+- avdd-pll-erefeut-supply: UPHY brick and reference clock as well as UTMI PHY
+ power supply. Must supply 1.8 V.
+- avdd-usb-supply: USB I/Os, VBUS, ID, REXT, D+/D- power supply. Must supply
+ 3.3 V.
+- vclamp-usb-supply: Bias rail for USB pad. Must supply 1.8 V.
+- vddio-hsic-supply: HSIC PHY power supply. Must supply 1.2 V.
+
Pad nodes:
==========
