Patch series introducing support for ROHM BD70528 PMIC Please note that patch 1 breaks compilation without patches 2 and 3 ROHM BD70528 is a programmable Power Management IC for battery powered 'ultra low power' systems like the pre-announced NXP i.MX7 ULP. This patch series introduces support for the PMIC. I send this a RFC now as I would like to receive comments from Lee, Mark and Stephen regarding splitting the existing include/linux/mfd/bd718x7.h into ROHM generic and chip specific portions. Benefit is that for example the clk sub-driver does not need to be aware of chip specific structure(s) (struct bd718x7 and struct bd70528) as it only needs to derefernce the generic struct rohm_regmap_dev. Thus same clk subdriver can support both the bd718x7 and bd70528 as long as MFD driver data has this generic structure in the beginning of allocated data. But knowing the bd718x7 driver is already in upstream, it might be good if this change went through single tree, right? RTC block of the bd70528 can support 'wake' irq which wakes PMIC from standby state. Wake irq's can be armed to wake up system up to 24 hours from arming. bd70528 can also generate alarm interrupts which can be armed to occur years after triggering. The RTC driver does always arm both the waker and alarm irqs and does not utilize longer period of alarm interrupts. All the RTC timers are limited to occur within the next 24 hours. Any suggestions on more elegant timer support are welcome =) GPIO portion of bd70528 driver adds I/O support for driving GPIO pins or reading the state. The interrupt functionality is provided by regmap-irq. Current GPIO driver is not aware of whether the pin(s) are used for I/O or interrupts and it is up-to driver user to ensure there is no misconfiguration or "double use". Currently only MFD core, clk, RTC and regulator portions are somehow tested. The RFC series also include initial gpio, power-supply and watchdog patches in order to provide better overview on chip and to collect initial feedback. Reset and ADC are not supported by this series. Changelog v2: Mainly feedback from Guenter Roeck: - patches 1, 2, 3, 5, 7, 9 are unchanged. - mfd: own mutex for each bd70528 instance - embed in struct bd70528 - watchdog: do not copy parent device data - watchdog: fix deadlock caused by double locked mutex - watchdog: set initial timeouts and WDT parent information - watchdog: remove unnecessary ping function from ops - watchdog: and the comment regarding it - watchdog: allocate watchdog struct in order to allow multiple WDG instances - rtc: bd70528 fix the order of mutex unlock and re-enabling RTC based timers - rtc: fix the irq mask register address - power: fix the irq mask register address - regulator/regmap-irq: Drop the patches 1, 8 and 9 from original series as those were already applied by Mark Patch 1: split the bd718x7.h to generic and chip specific portions. (breaks compilation without patch 2 and 3) Patch 2: adapt bd718x7.h changes to bd718x7 regulator driver Patch 3: adapt bd718x7.h changes to bd718x7 clk driver Patch 4: add MFD core support for bd70528 Patch 5: support bd70528 clk using bd718x7 clk driver Patch 6: document DT bindings for BD70528 Patch 7: support BD70528 GPIO block Patch 8: support BD70528 RTC Patch 9: support BD70528 battery charger Patch 10: support BD70528 watchdog This patch series is based on Mark's regulator/for-next branch --- Matti Vaittinen (10): mfd: bd718x7.h split to ROHM common and bd718x7 specific parts regulator: bd718x7 use chip specific and generic data structs clk: bd718x7: use chip specific and generic data structs mfd: bd70528: Support ROHM bd70528 PMIC - core clk: bd718x7: Support ROHM BD70528 clk block devicetree: bindings: Document first ROHM BD70528 bindings gpio: Initial support for ROHM bd70528 GPIO block rtc: bd70528: Initial support for ROHM bd70528 RTC power: supply: Initial support for ROHM BD70528 PMIC charger block watchdog: bd70528: Initial support for ROHM BD70528 watchdog block .../devicetree/bindings/mfd/rohm,bd70528-pmic.txt | 104 ++++ drivers/clk/Kconfig | 6 +- drivers/clk/clk-bd718x7.c | 25 +- drivers/gpio/Kconfig | 11 + drivers/gpio/Makefile | 1 + drivers/gpio/gpio-bd70528.c | 192 ++++++ drivers/mfd/Kconfig | 17 + drivers/mfd/Makefile | 1 + drivers/mfd/rohm-bd70528.c | 410 +++++++++++++ drivers/mfd/rohm-bd718x7.c | 23 +- drivers/power/supply/Kconfig | 9 + drivers/power/supply/Makefile | 1 + drivers/power/supply/bd70528-charger.c | 670 +++++++++++++++++++++ drivers/regulator/bd718x7-regulator.c | 22 +- drivers/rtc/Kconfig | 8 + drivers/rtc/Makefile | 1 + drivers/rtc/rtc-bd70528.c | 451 ++++++++++++++ drivers/watchdog/Kconfig | 12 + drivers/watchdog/Makefile | 1 + drivers/watchdog/bd70528_wdt.c | 183 ++++++ include/linux/mfd/rohm-bd70528.h | 392 ++++++++++++ include/linux/mfd/rohm-bd718x7.h | 22 +- include/linux/mfd/rohm-generic.h | 20 + 23 files changed, 2537 insertions(+), 45 deletions(-) create mode 100644 Documentation/devicetree/bindings/mfd/rohm,bd70528-pmic.txt create mode 100644 drivers/gpio/gpio-bd70528.c create mode 100644 drivers/mfd/rohm-bd70528.c create mode 100644 drivers/power/supply/bd70528-charger.c create mode 100644 drivers/rtc/rtc-bd70528.c create mode 100644 drivers/watchdog/bd70528_wdt.c create mode 100644 include/linux/mfd/rohm-bd70528.h create mode 100644 include/linux/mfd/rohm-generic.h -- 2.14.3 -- Matti Vaittinen ROHM Semiconductors ~~~ "I don't think so," said Rene Descartes. Just then, he vanished ~~~
