On 1/22/19 4:33 PM, Florian Fainelli wrote: > On 32-bit architectures defining resource_size_t as 64-bit (because of > PAE), we can run into a linker failure because of the modulo and the > division against resource_size(), replace the two problematic operations > with an alignment check on the register resource (instead of modulo), > and the division with DIV_ROUND_CLOSEST_ULL(). > > Reported-by: Randy Dunlap <rdunlap@xxxxxxxxxxxxx> > Fixes: c196cdc7659d ("reset: Add Broadcom STB SW_INIT reset controller driver") > Signed-off-by: Florian Fainelli <f.fainelli@xxxxxxxxx> > --- > drivers/reset/reset-brcmstb.c | 6 ++++-- > 1 file changed, 4 insertions(+), 2 deletions(-) > > diff --git a/drivers/reset/reset-brcmstb.c b/drivers/reset/reset-brcmstb.c > index 01ab1f71518b..c4cab8b5052d 100644 > --- a/drivers/reset/reset-brcmstb.c > +++ b/drivers/reset/reset-brcmstb.c > @@ -91,7 +91,8 @@ static int brcmstb_reset_probe(struct platform_device *pdev) > return -ENOMEM; > > res = platform_get_resource(pdev, IORESOURCE_MEM, 0); > - if (resource_size(res) % SW_INIT_BANK_SIZE) { > + if (!IS_ALIGNED(res->start, SW_INIT_BANK_SIZE) || > + !IS_AGLINED(resource_size(res), SW_INIT_BANK_SIZE)) { > dev_err(kdev, "incorrect register range\n"); > return -EINVAL; > } > @@ -103,7 +104,8 @@ static int brcmstb_reset_probe(struct platform_device *pdev) > dev_set_drvdata(kdev, priv); > > priv->rcdev.owner = THIS_MODULE; > - priv->rcdev.nr_resets = (resource_size(res) / SW_INIT_BANK_SIZE) * 32; > + priv->rcdev.nr_resets = DIV_ROUND_CLOSEST_ULL(resource_size(res), > + SW_INIT_BANK_SIZE) * 32; > priv->rcdev.ops = &brcmstb_reset_ops; > priv->rcdev.of_node = kdev->of_node; > /* Use defaults: 1 cell and simple xlate function */ > Hi Florian, This gives me: CC drivers/reset/reset-brcmstb.o ../drivers/reset/reset-brcmstb.c: In function ‘brcmstb_reset_probe’: ../drivers/reset/reset-brcmstb.c:95:6: error: implicit declaration of function ‘IS_AGLINED’ [-Werror=implicit-function-declaration] !IS_AGLINED(resource_size(res), SW_INIT_BANK_SIZE)) { ^ but if the typo is fixed, it is fine :) then you can added: Acked-by: Randy Dunlap <rdunlap@xxxxxxxxxxxxx> Thanks. -- ~Randy