Hi, Vignesh,
On 01/16/2019 12:30 PM, Vignesh R wrote:
> Cadence OSPI controller IP supports Octal IO (x8 IO lines),
> It also has an integrated PHY. IP register layout is very
> similar to existing QSPI IP except for additional bits to support Octal
> and Octal DDR mode. Therefore, extend current driver to support Octal
> mode.
>
> Signed-off-by: Vignesh R <vigneshr@xxxxxx>
> ---
> v3: No changes
>
> v2:
> Declare Octal mode capability based on compatible.
>
> drivers/mtd/spi-nor/cadence-quadspi.c | 54 +++++++++++++++++++++------
> 1 file changed, 42 insertions(+), 12 deletions(-)
>
> diff --git a/drivers/mtd/spi-nor/cadence-quadspi.c b/drivers/mtd/spi-nor/cadence-quadspi.c
> index 04cedd3a2bf6..31ed50f78972 100644
> --- a/drivers/mtd/spi-nor/cadence-quadspi.c
> +++ b/drivers/mtd/spi-nor/cadence-quadspi.c
> @@ -93,6 +93,11 @@ struct cqspi_st {
> struct cqspi_flash_pdata f_pdata[CQSPI_MAX_CHIPSELECT];
> };
>
> +struct cqspi_driver_platdata {
> + u32 hwcaps_mask;
> + u8 quirks;
> +};
> +
> /* Operation timeout value */
> #define CQSPI_TIMEOUT_MS 500
> #define CQSPI_READ_TIMEOUT_MS 10
> @@ -101,6 +106,7 @@ struct cqspi_st {
> #define CQSPI_INST_TYPE_SINGLE 0
> #define CQSPI_INST_TYPE_DUAL 1
> #define CQSPI_INST_TYPE_QUAD 2
> +#define CQSPI_INST_TYPE_OCTAL 3
>
> #define CQSPI_DUMMY_CLKS_PER_BYTE 8
> #define CQSPI_DUMMY_BYTES_MAX 4
> @@ -911,6 +917,9 @@ static int cqspi_set_protocol(struct spi_nor *nor, const int read)
> case SNOR_PROTO_1_1_4:
> f_pdata->data_width = CQSPI_INST_TYPE_QUAD;
> break;
> + case SNOR_PROTO_1_1_8:
> + f_pdata->data_width = CQSPI_INST_TYPE_OCTAL;
> + break;
> default:
> return -EINVAL;
> }
> @@ -1213,21 +1222,19 @@ static void cqspi_request_mmap_dma(struct cqspi_st *cqspi)
>
> static int cqspi_setup_flash(struct cqspi_st *cqspi, struct device_node *np)
> {
> - const struct spi_nor_hwcaps hwcaps = {
> - .mask = SNOR_HWCAPS_READ |
> - SNOR_HWCAPS_READ_FAST |
> - SNOR_HWCAPS_READ_1_1_2 |
> - SNOR_HWCAPS_READ_1_1_4 |
> - SNOR_HWCAPS_PP,
> - };
> struct platform_device *pdev = cqspi->pdev;
> struct device *dev = &pdev->dev;
> + struct cqspi_driver_platdata *ddata;
const struct cqspi_driver_platdata *ddata;
> + struct spi_nor_hwcaps hwcaps;
> struct cqspi_flash_pdata *f_pdata;
> struct spi_nor *nor;
> struct mtd_info *mtd;
> unsigned int cs;
> int i, ret;
>
> + ddata = (struct cqspi_driver_platdata *)of_device_get_match_data(dev);
You forgot to check for NULL. Also, I would expect an implicit type cast, you
can drop the explicit cast.
> + hwcaps.mask = ddata->hwcaps_mask;
> +
> /* Get flash device data */
> for_each_available_child_of_node(dev->of_node, np) {
> ret = of_property_read_u32(np, "reg", &cs);
> @@ -1310,7 +1317,7 @@ static int cqspi_probe(struct platform_device *pdev)
> struct cqspi_st *cqspi;
> struct resource *res;
> struct resource *res_ahb;
> - unsigned long data;
> + struct cqspi_driver_platdata *ddata;
const struct cqspi_driver_platdata *ddata;
> int ret;
> int irq;
>
> @@ -1377,8 +1384,8 @@ static int cqspi_probe(struct platform_device *pdev)
> }
>
> cqspi->master_ref_clk_hz = clk_get_rate(cqspi->clk);
> - data = (unsigned long)of_device_get_match_data(dev);
> - if (data & CQSPI_NEEDS_WR_DELAY)
> + ddata = (struct cqspi_driver_platdata *)of_device_get_match_data(dev);
I would expect an implicit type cast, you can drop the explicit cast.
> + if (ddata && (ddata->quirks & CQSPI_NEEDS_WR_DELAY))
> cqspi->wr_delay = 5 * DIV_ROUND_UP(NSEC_PER_SEC,
> cqspi->master_ref_clk_hz);
>
> @@ -1460,14 +1467,37 @@ static const struct dev_pm_ops cqspi__dev_pm_ops = {
> #define CQSPI_DEV_PM_OPS NULL
> #endif
>
> +#define cqspi_base_hwcaps_mask \
> + (SNOR_HWCAPS_READ | SNOR_HWCAPS_READ_FAST | \
> + SNOR_HWCAPS_READ_1_1_2 | SNOR_HWCAPS_READ_1_1_4 | \
> + SNOR_HWCAPS_PP)
> +
> +static const struct cqspi_driver_platdata cdns_qspi = {
> + .hwcaps_mask = cqspi_base_hwcaps_mask,
> +};
> +
> +static const struct cqspi_driver_platdata k2g_qspi = {
> + .hwcaps_mask = cqspi_base_hwcaps_mask,
> + .quirks = CQSPI_NEEDS_WR_DELAY,
> +};
> +
> +static const struct cqspi_driver_platdata am654_ospi = {
> + .hwcaps_mask = cqspi_base_hwcaps_mask | SNOR_HWCAPS_READ_1_1_8,
> + .quirks = CQSPI_NEEDS_WR_DELAY,
> +};
> +
> static const struct of_device_id cqspi_dt_ids[] = {
> {
> .compatible = "cdns,qspi-nor",
> - .data = (void *)0,
> + .data = (void *)&cdns_qspi,
You can drop the (void *) cast.
Looks good. Did you test the octal mode with mt35xu512aba? If yes, it would be
nice to specify this in the commit message.
Cheers,
ta
> },
> {
> .compatible = "ti,k2g-qspi",
> - .data = (void *)CQSPI_NEEDS_WR_DELAY,
> + .data = (void *)&k2g_qspi,
> + },
> + {
> + .compatible = "ti,am654-ospi",
> + .data = (void *)&am654_ospi,
> },
> { /* end of table */ }
> };
>
