On 02/01/2019 14:26, Lokesh Vutla wrote:
Hi Peter,
On 02/01/19 5:19 PM, Peter Ujfalusi wrote:
On 27/12/2018 8.13, Lokesh Vutla wrote:
Texas Instruments' K3 generation SoCs has an IP Interrupt Aggregator
which is an interrupt controller that does the following:
- Converts events to interrupts that can be understood by
an interrupt router.
- Allows for multiplexing of events to interrupts.
Configuration of the interrupt aggregator registers can only be done by
a system co-processor and the driver needs to send a message to this
co processor over TISCI protocol.
Add support for Interrupt Aggregator driver over TISCI protocol.
Signed-off-by: Lokesh Vutla <lokeshvutla@xxxxxx>
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@xxxxxx>
---
MAINTAINERS | 1 +
drivers/irqchip/Kconfig | 12 +
drivers/irqchip/Makefile | 1 +
drivers/irqchip/irq-ti-sci-inta.c | 561 ++++++++++++++++++++++++++++++
4 files changed, 575 insertions(+)
create mode 100644 drivers/irqchip/irq-ti-sci-inta.c
diff --git a/MAINTAINERS b/MAINTAINERS
index aebce615151e..7d12788c844a 100644
--- a/MAINTAINERS
+++ b/MAINTAINERS
@@ -15026,6 +15026,7 @@ F: drivers/reset/reset-ti-sci.c
F:
Documentation/devicetree/bindings/interrupt-controller/ti,sci-intr.txt
F:
Documentation/devicetree/bindings/interrupt-controller/ti,sci-inta.txt
F: drivers/irqchip/irq-ti-sci-intr.c
+F: drivers/irqchip/irq-ti-sci-inta.c
Texas Instruments ASoC drivers
M: Peter Ujfalusi <peter.ujfalusi@xxxxxx>
diff --git a/drivers/irqchip/Kconfig b/drivers/irqchip/Kconfig
index a8d9bed0254b..d16fd39408ad 100644
--- a/drivers/irqchip/Kconfig
+++ b/drivers/irqchip/Kconfig
@@ -417,6 +417,18 @@ config TI_SCI_INTR_IRQCHIP
If you wish to use interrupt router irq resources managed by the
TI System Controller, say Y here. Otherwise, say N.
+config TI_SCI_INTA_IRQCHIP
+ bool
+ depends on TI_SCI_PROTOCOL && ARCH_K3
+ select IRQ_DOMAIN
+ select IRQ_DOMAIN_HIERARCHY
+ select K3_INTA_MSI_DOMAIN
+ help
+ This enables the irqchip driver support for K3 Interrupt
aggregator
+ over TI System Control Interface available on some new TI's SoCs.
+ If you wish to use interrupt aggregator irq resources managed
by the
+ TI System Controller, say Y here. Otherwise, say N.
+
endmenu
config SIFIVE_PLIC
diff --git a/drivers/irqchip/Makefile b/drivers/irqchip/Makefile
index b4ff376a08ef..a679490a7059 100644
--- a/drivers/irqchip/Makefile
+++ b/drivers/irqchip/Makefile
@@ -95,3 +95,4 @@ obj-$(CONFIG_SIFIVE_PLIC) += irq-sifive-plic.o
obj-$(CONFIG_IMX_IRQSTEER) += irq-imx-irqsteer.o
obj-$(CONFIG_MADERA_IRQ) += irq-madera.o
obj-$(CONFIG_TI_SCI_INTR_IRQCHIP) += irq-ti-sci-intr.o
+obj-$(CONFIG_TI_SCI_INTA_IRQCHIP) += irq-ti-sci-inta.o
diff --git a/drivers/irqchip/irq-ti-sci-inta.c
b/drivers/irqchip/irq-ti-sci-inta.c
new file mode 100644
index 000000000000..78bfc83a079a
--- /dev/null
+++ b/drivers/irqchip/irq-ti-sci-inta.c
@@ -0,0 +1,561 @@
+// SPDX-License-Identifier: GPL-2.0
+/*
+ * Texas Instruments' K3 Interrupt Aggregator irqchip driver
+ *
+ * Copyright (C) 2018 Texas Instruments Incorporated -
http://www.ti.com/
+ * Lokesh Vutla <lokeshvutla@xxxxxx>
+ */
+
+#include <linux/err.h>
+#include <linux/io.h>
+#include <linux/msi.h>
+#include <linux/irqchip.h>
+#include <linux/of_platform.h>
+#include <linux/of_address.h>
+#include <linux/of_irq.h>
+#include <linux/module.h>
+#include <linux/moduleparam.h>
+#include <linux/irqdomain.h>
To fix this:
drivers/irqchip/irq-ti-sci-inta.c: In function ‘inta_msi_irq_handler’:
drivers/irqchip/irq-ti-sci-inta.c:308:8: error: ‘IRQF_TRIGGER_HIGH’
undeclared (first use in this function); did you mean
‘IRQD_TRIGGER_MASK’?
IRQF_TRIGGER_HIGH)
^~~~~~~~~~~~~~~~~
IRQD_TRIGGER_MASK
drivers/irqchip/irq-ti-sci-inta.c:308:8: note: each undeclared
identifier is reported only once for each function it appears in
drivers/irqchip/irq-ti-sci-inta.c: In function
‘ti_sci_inta_alloc_parent_irq’:
drivers/irqchip/irq-ti-sci-inta.c:360:27: error: ‘IRQF_TRIGGER_HIGH’
undeclared (first use in this function); did you mean
‘IRQD_TRIGGER_MASK’?
parent_fwspec.param[2] = IRQF_TRIGGER_HIGH;
^~~~~~~~~~~~~~~~~
IRQD_TRIGGER_MASK
make[3]: *** [scripts/Makefile.build:276:
drivers/irqchip/irq-ti-sci-inta.o] Error 1
Add this:
#include <linux/interrupt.h>
I did not see any such build error during my testing as shown below. But
agree about the report. Will fix it in next version
➜ linux git:(nex-master) v8make defconfig
HOSTCC scripts/basic/fixdep
HOSTCC scripts/kconfig/conf.o
HOSTCC scripts/kconfig/confdata.o
HOSTCC scripts/kconfig/expr.o
HOSTCC scripts/kconfig/symbol.o
HOSTCC scripts/kconfig/preprocess.o
LEX scripts/kconfig/zconf.lex.c
YACC scripts/kconfig/zconf.tab.h
HOSTCC scripts/kconfig/zconf.lex.o
YACC scripts/kconfig/zconf.tab.c
HOSTCC scripts/kconfig/zconf.tab.o
v8 HOSTLD scripts/kconfig/conf
*** Default configuration is based on 'defconfig'
make #
# configuration written to .config
#
I%
➜ linux git:(nex-master) v8make Image
dtbs -j4 -s
arch/arm64/boot/dts/rockchip/rk3399-gru-bob.dts:25.9-29.5: Warning
(graph_port): /edp-panel/ports: graph port node name should be 'port'
arch/arm64/boot/dts/rockchip/rk3399-gru-kevin.dts:46.9-50.5: Warning
(graph_port): /edp-panel/ports: graph port node name should be 'port'
arch/arm64/boot/dts/rockchip/rk3399-sapphire-excavator.dts:94.9-98.5:
Warning (graph_port): /edp-panel/ports: graph port node name should be
'port'
<stdin>:1339:2: warning: #warning syscall open_tree not implemented [-Wcpp]
<stdin>:1342:2: warning: #warning syscall move_mount not implemented
[-Wcpp]
<stdin>:1345:2: warning: #warning syscall fsopen not implemented [-Wcpp]
<stdin>:1348:2: warning: #warning syscall fsconfig not implemented [-Wcpp]
<stdin>:1351:2: warning: #warning syscall fsmount not implemented [-Wcpp]
<stdin>:1354:2: warning: #warning syscall fspick not implemented [-Wcpp]
➜ linux git:(nex-master)
Thanks and regards,
Lokesh
The mentioned failure only happens with a specific .config. Not sure
what is the actual Kconfig that masks the failure though, but anyway it
looks like interrupt.h gets included via some indirect path with arm64
defconfig making it pass.
-Tero
--
Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki. Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki
