Add interrupt controller properties now that spmi-gpio is a proper
hierarchical IRQ chip. The interrupts property is no longer needed so
remove it.
This change was not tested on any hardware but the same change was
tested on qcom-pm8941.dtsi using a LG Nexus 5 (hammerhead) phone with
no issues.
Signed-off-by: Brian Masney <masneyb@xxxxxxxxxxxxx>
Reviewed-by: Stephen Boyd <sboyd@xxxxxxxxxx>
---
Chances since v3:
- None
arch/arm/boot/dts/qcom-pma8084.dtsi | 24 ++----------------------
1 file changed, 2 insertions(+), 22 deletions(-)
diff --git a/arch/arm/boot/dts/qcom-pma8084.dtsi b/arch/arm/boot/dts/qcom-pma8084.dtsi
index aac7e73b6872..8f5ea7add20f 100644
--- a/arch/arm/boot/dts/qcom-pma8084.dtsi
+++ b/arch/arm/boot/dts/qcom-pma8084.dtsi
@@ -32,28 +32,8 @@
reg = <0xc000>;
gpio-controller;
#gpio-cells = <2>;
- interrupts = <0 0xc0 0 IRQ_TYPE_NONE>,
- <0 0xc1 0 IRQ_TYPE_NONE>,
- <0 0xc2 0 IRQ_TYPE_NONE>,
- <0 0xc3 0 IRQ_TYPE_NONE>,
- <0 0xc4 0 IRQ_TYPE_NONE>,
- <0 0xc5 0 IRQ_TYPE_NONE>,
- <0 0xc6 0 IRQ_TYPE_NONE>,
- <0 0xc7 0 IRQ_TYPE_NONE>,
- <0 0xc8 0 IRQ_TYPE_NONE>,
- <0 0xc9 0 IRQ_TYPE_NONE>,
- <0 0xca 0 IRQ_TYPE_NONE>,
- <0 0xcb 0 IRQ_TYPE_NONE>,
- <0 0xcc 0 IRQ_TYPE_NONE>,
- <0 0xcd 0 IRQ_TYPE_NONE>,
- <0 0xce 0 IRQ_TYPE_NONE>,
- <0 0xcf 0 IRQ_TYPE_NONE>,
- <0 0xd0 0 IRQ_TYPE_NONE>,
- <0 0xd1 0 IRQ_TYPE_NONE>,
- <0 0xd2 0 IRQ_TYPE_NONE>,
- <0 0xd3 0 IRQ_TYPE_NONE>,
- <0 0xd4 0 IRQ_TYPE_NONE>,
- <0 0xd5 0 IRQ_TYPE_NONE>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
};
pma8084_mpps: mpps@a000 {
--
2.17.2
