On Tue, Nov 06, 2018 at 09:46:47PM +0100, Marek Vasut wrote:
> From: Takeshi Kihara <takeshi.kihara.df@xxxxxxxxxxx>
>
> This patch adds SDHI{0,1,3} device nodes for the r8a77990 SoC
> and enables SD card slot connected to SDHI0, micro SD card slot
> connected to SDHI1 and eMMC connected to SDHI3 on the Ebisu board
> using the R8A77990 SoC.
>
> Signed-off-by: Takeshi Kihara <takeshi.kihara.df@xxxxxxxxxxx>
> Signed-off-by: Marek Vasut <marek.vasut+renesas@xxxxxxxxx>
> Cc: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>
> Cc: Simon Horman <horms+renesas@xxxxxxxxxxxx>
> Cc: Wolfram Sang <wsa@xxxxxxxxxxxxx>
> Cc: Yoshihiro Shimoda <yoshihiro.shimoda.uh@xxxxxxxxxxx>
> Cc: linux-renesas-soc@xxxxxxxxxxxxxxx
> Cc: linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
> ---
> V2: - Deduplicated regular and UHS pins
> - Added sdhi3_ds pin pinmux
> V3: - Squash two patches, one adding SDHI nodes to R8A77990 E3 DTSI
> and another enabling them on E3 Ebisu, together.
Hi,
I am wondering if something special is required in order to use eMMC
connected to SDHI3. Using renesas-drivers-2019-01-08-v5.0-rc1 I do not see
that device initialised to the point where a corresponding block device is
present.
[ 0.000127] NOTICE: BL2: R-Car Gen3 Initial Program Loader(CA53)
Rev.1.0.21
[ 0.005703] NOTICE: BL2: PRR is R-Car E3 Ver.1.0
[ 0.010361] NOTICE: BL2: PLL1 nonSSCG Clock select
[ 0.015356] NOTICE: BL2: Board is Ebisu-4D Rev.1.0
[ 0.020041] NOTICE: BL2: Boot device is HyperFlash(80MHz)
[ 0.025479] NOTICE: BL2: LCM state is CM
[ 0.029445] NOTICE: BL2: 0x400000000 - 0x480000000, 2 GiB
[ 0.034877] NOTICE: BL2: DDR1856(rev.0.07)NOTICE: ..0
[ 0.040425] NOTICE: BL2: DRAM Split is OFF
[ 0.044304] NOTICE: BL2: QoS is default setting(rev.0.02)
[ 0.049748] NOTICE: BL2: DRAM refresh interval 3.9 usec
[ 0.055089] NOTICE: BL2: v1.4(release):15dba6b-dirty
[ 0.060029] NOTICE: BL2: Built : 04:48:01, Jun 26 2018
[ 0.065217] NOTICE: BL2: Normal boot
[ 0.068872] NOTICE: BL2: dst=0xe6311d00 src=0x8180000 len=512(0x200)
[ 0.075247] NOTICE: BL2: dst=0x43f00000 src=0x8180400 len=6144(0x1800)
[ 0.081874] NOTICE: BL2: dst=0x44000000 src=0x81c0000 len=65536(0x10000)
[ 0.089118] NOTICE: BL2: dst=0x44100000 src=0x8200000 len=1048576(0x100000)
[ 0.103992] NOTICE: BL2: dst=0x50000000 src=0x8640000 len=1048576(0x100000)
# dmesg | egrep "(sd|mmc)"
[ 2.872441] renesas_sdhi_internal_dmac ee100000.sd: Got CD GPIO
[ 2.878587] renesas_sdhi_internal_dmac ee100000.sd: Got WP GPIO
[ 2.885806] renesas_sdhi_internal_dmac ee120000.sd: Got CD GPIO
[ 2.893284] renesas_sdhi_internal_dmac ee160000.sd: Linked as a consumer to regulator.2
[ 2.901602] renesas_sdhi_internal_dmac ee160000.sd: Linked as a consumer to regulator.1
[ 2.909708] renesas_sdhi_internal_dmac ee160000.sd: Failed getting OCR mask: 0
[ 2.917236] renesas_sdhi_internal_dmac ee160000.sd: Dropping the link to regulator.1
[ 2.925214] renesas_sdhi_internal_dmac ee160000.sd: Dropping the link to regulator.2
[ 3.295711] renesas_sdhi_internal_dmac ee100000.sd: Got CD GPIO
[ 3.301808] renesas_sdhi_internal_dmac ee100000.sd: Got WP GPIO
[ 3.308042] renesas_sdhi_internal_dmac ee100000.sd: Linked as a consumer to regulator.4
[ 3.316268] renesas_sdhi_internal_dmac ee100000.sd: Linked as a consumer to regulator.6
[ 3.373714] renesas_sdhi_internal_dmac ee100000.sd: mmc0 base at 0xee100000 max clock rate 200 MHz
[ 3.384547] renesas_sdhi_internal_dmac ee120000.sd: Got CD GPIO
[ 3.390915] renesas_sdhi_internal_dmac ee120000.sd: Linked as a consumer to regulator.5
[ 3.399171] renesas_sdhi_internal_dmac ee120000.sd: Linked as a consumer to regulator.7
[ 3.456829] renesas_sdhi_internal_dmac ee120000.sd: mmc1 base at 0xee120000 max clock rate 200 MHz
[ 3.468133] renesas_sdhi_internal_dmac ee160000.sd: Linked as a consumer to regulator.2
[ 3.476448] renesas_sdhi_internal_dmac ee160000.sd: Linked as a consumer to regulator.1
[ 3.484635] renesas_sdhi_internal_dmac ee160000.sd: Failed getting OCR mask: 0
[ 3.492147] renesas_sdhi_internal_dmac ee160000.sd: Dropping the link to regulator.1
[ 3.500110] renesas_sdhi_internal_dmac ee160000.sd: Dropping the link to regulator.2
[ 3.562322] renesas_sdhi_internal_dmac ee160000.sd: Linked as a consumer to regulator.2
[ 3.570834] renesas_sdhi_internal_dmac ee160000.sd: Linked as a consumer to regulator.1
[ 3.579021] renesas_sdhi_internal_dmac ee160000.sd: Failed getting OCR mask: 0
[ 3.586657] renesas_sdhi_internal_dmac ee160000.sd: Dropping the link to regulator.1
[ 3.594653] renesas_sdhi_internal_dmac ee160000.sd: Dropping the link to regulator.2
[ 3.640782] renesas_sdhi_internal_dmac ee160000.sd: Linked as a consumer to regulator.2
[ 3.649110] renesas_sdhi_internal_dmac ee160000.sd: Linked as a consumer to regulator.1
[ 3.657213] renesas_sdhi_internal_dmac ee160000.sd: Failed getting OCR mask: 0
[ 3.664677] renesas_sdhi_internal_dmac ee160000.sd: Dropping the link to regulator.1
[ 3.672599] renesas_sdhi_internal_dmac ee160000.sd: Dropping the link to regulator.2
[ 3.688811] mmc0: new ultra high speed SDR104 SDXC card at address 0007
[ 3.698572] mmcblk0: mmc0:0007 SL64G 58.3 GiB
[ 3.726399] mmcblk0: p1
[ 3.763694] mmc1: new ultra high speed SDR104 SDHC card at address 0001
[ 3.772525] renesas_sdhi_internal_dmac ee160000.sd: Linked as a consumer to regulator.2
[ 3.781623] mmcblk1: mmc1:0001 00000 29.8 GiB
[ 3.786779] renesas_sdhi_internal_dmac ee160000.sd: Linked as a consumer to regulator.1
[ 3.795548] renesas_sdhi_internal_dmac ee160000.sd: Failed getting OCR mask: 0
[ 3.803099] renesas_sdhi_internal_dmac ee160000.sd: Dropping the link to regulator.1
[ 3.811006] mmcblk1: p1
[ 3.815437] renesas_sdhi_internal_dmac ee160000.sd: Dropping the link to regulator.2
[ 3.856991] renesas_sdhi_internal_dmac ee160000.sd: Linked as a consumer to regulator.2
[ 3.865263] renesas_sdhi_internal_dmac ee160000.sd: Linked as a consumer to regulator.1
[ 3.873371] renesas_sdhi_internal_dmac ee160000.sd: Failed getting OCR mask: 0
[ 3.880864] renesas_sdhi_internal_dmac ee160000.sd: Dropping the link to regulator.1
[ 3.888786] renesas_sdhi_internal_dmac ee160000.sd: Dropping the link to regulator.2
