On Wed, Dec 19, 2018 at 02:55:51PM -0800, Sowjanya Komatineni wrote:
> Add pinctrl for 3V3 and 1V8 pad drive strength configuration for
> Tegra210 sdmmc which has pad configuration registers in the pinmux
> reigster domain.
typo
>
> Signed-off-by: Sowjanya Komatineni <skomatineni@xxxxxxxxxx>
> ---
> Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt | 6 +++++-
> 1 file changed, 5 insertions(+), 1 deletion(-)
>
> diff --git a/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt b/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt
> index 32b4b4e41923..2cecdc71d94c 100644
> --- a/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt
> +++ b/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt
> @@ -39,12 +39,16 @@ sdhci@c8000200 {
> bus-width = <8>;
> };
>
> -Optional properties for Tegra210 and Tegra186:
> +Optional properties for Tegra210, Tegra186 and Tegra194:
Adding Tegra194, but this patch concerns Tegra210...
> - pinctrl-names, pinctrl-0, pinctrl-1 : Specify pad voltage
> configurations. Valid pinctrl-names are "sdmmc-3v3" and "sdmmc-1v8"
> for controllers supporting multiple voltage levels. The order of names
> should correspond to the pin configuration states in pinctrl-0 and
> pinctrl-1.
> +- pinctrl-names : "sdmmc-3v3-drv" and "sdmmc-1v8-drv" are applicable for
These are in addition to the previous values?
> + Tegra210 where pad config registers are in the pinmux register domain
> + for pull-up-strength and pull-down-strength values configuration when
> + using pads at 3V3 and 1V8 levels.
> - nvidia,only-1-8-v : The presence of this property indicates that the
> controller operates at a 1.8 V fixed I/O voltage.
> - nvidia,pad-autocal-pull-up-offset-3v3,
> --
> 2.7.4
>
