Add the board level fixed regulators for 3.3V and 1.8V which is used to
power - among other things - the tlv320aic3106 codec.
Apart from removing the following warning during boot:
tlv320aic3x-codec 0-0018: Too high supply voltage(s) AVDD: 5000000, DVDD: 5000000
With the correct voltages the driver can select correct OCMV value to
reduce pop noise.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@xxxxxx>
---
arch/arm/boot/dts/da850-evm.dts | 29 +++++++++++++++++++++++++----
1 file changed, 25 insertions(+), 4 deletions(-)
diff --git a/arch/arm/boot/dts/da850-evm.dts b/arch/arm/boot/dts/da850-evm.dts
index f9a5a8212c84..997bede2a48f 100644
--- a/arch/arm/boot/dts/da850-evm.dts
+++ b/arch/arm/boot/dts/da850-evm.dts
@@ -94,6 +94,28 @@
regulator-boot-on;
};
+ baseboard_3v3: fixedregulator-3v3 {
+ /* TPS73701DCQ */
+ compatible = "regulator-fixed";
+ regulator-name = "baseboard_3v3";
+ regulator-min-microvolt = <3300000>;
+ regulator-max-microvolt = <3300000>;
+ vin-supply = <&vbat>;
+ regulator-always-on;
+ regulator-boot-on;
+ };
+
+ baseboard_1v8: fixedregulator-1v8 {
+ /* TPS73701DCQ */
+ compatible = "regulator-fixed";
+ regulator-name = "baseboard_1v8";
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <1800000>;
+ vin-supply = <&vbat>;
+ regulator-always-on;
+ regulator-boot-on;
+ };
+
backlight_lcd: backlight-regulator {
compatible = "regulator-fixed";
regulator-name = "lcd_backlight_pwr";
@@ -210,10 +232,9 @@
/* Regulators */
IOVDD-supply = <&vdcdc2_reg>;
- /* Derived from VBAT: Baseboard 3.3V / 1.8V */
- AVDD-supply = <&vbat>;
- DRVDD-supply = <&vbat>;
- DVDD-supply = <&vbat>;
+ AVDD-supply = <&baseboard_3v3>;
+ DRVDD-supply = <&baseboard_3v3>;
+ DVDD-supply = <&baseboard_1v8>;
};
tca6416: gpio@20 {
compatible = "ti,tca6416";
--
Peter
Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki.
Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki
