On Mon, Dec 03, 2018 at 06:35:05PM +0800, Xiaowei Bao wrote:
> Add the layerscape EP device support in pci_endpoint_test driver.
>
> Signed-off-by: Xiaowei Bao <xiaowei.bao@xxxxxxx>
> ---
> v2:
> - no change
> v3:
> - no change
>
> drivers/misc/pci_endpoint_test.c | 2 ++
> 1 files changed, 2 insertions(+), 0 deletions(-)
>
> diff --git a/drivers/misc/pci_endpoint_test.c b/drivers/misc/pci_endpoint_test.c
> index 896e2df..744d10c 100644
> --- a/drivers/misc/pci_endpoint_test.c
> +++ b/drivers/misc/pci_endpoint_test.c
> @@ -788,6 +788,8 @@ static void pci_endpoint_test_remove(struct pci_dev *pdev)
> static const struct pci_device_id pci_endpoint_test_tbl[] = {
> { PCI_DEVICE(PCI_VENDOR_ID_TI, PCI_DEVICE_ID_TI_DRA74x) },
> { PCI_DEVICE(PCI_VENDOR_ID_TI, PCI_DEVICE_ID_TI_DRA72x) },
> + /* 0x81c0: The device id of ls1046a in NXP. */
There is no need for a comment, just this line is fine:
> + { PCI_DEVICE(PCI_VENDOR_ID_FREESCALE, 0x81c0) },
If you note, no other lines have comments.
If you want to say that this is a specific device, then use a #define
with that device name and then use that define here, like the
PCI_DEVICE_ID_TI_DRA72x was done.
thanks,
greg k-h
