On Wed, Dec 12, 2018 at 3:59 AM Pavel Machek <pavel@xxxxxx> wrote:
>
> Hi!
>
> > > We would also probably need different DT properties for different
> > > types of devices, since e.g. for network case the network interface
> > > name would fit better for the LED name, than the phy name,
> > > and we would need to know what type of device name we're going
> > > to look for.
> > >
> > > Pavel gave following examples:
> > >
> > > eth0:green:link
> > > adsl0:green:link
> > > adsl0:red:error
> > >
> > > So we would have e.g.:
> > >
> > > associated-vl42-device = <&camera1>;
> > > associated-network-device = <&phy1>;
> > > associated-block-device = <&phy1>;
> >
> > Variable property names are kind of a pain to parse.
> >
> > Perhaps when LEDs are associated with a device, we shouldn't care
> > within the context of the LED subsystem what the name is. The
> > association is more important and if you have that exposed, then you
> > don't really need to care what the name is. You still have to deal
> > with a device with more than 1 LED, but that becomes a problem local
> > to that device.
> >
> > What I'm getting at is following a more standard binding pattern of
> > providers and consumers like we have for gpios, clocks, etc. So we'd
> > have something like this:
> >
> > ethernet {
> > ...
> > leds = <&green_led>, <&red_led>;
> > led-names = "link", "err";
> > };
> >
> > We can still support defining LED names as we've done, but we don't
> > have to come up with some elaborate naming convention that covers
> > every single case.
>
> I see that it would be more consistent with how gpios work, but I'm
> afraid this does not fit LEDs properly.
>
> With power LED, you want to be able to say "this is just on". Some
> poeple like heartbeat, and have LED for that. There may be LED for
> "disk activity", meaning activity on any harddrive. And there may be
> activity LED for specific disk.
>
> Only in the last case it would be suitable to have LED reference as a
> child of an device...
Right. For all the other cases, why do you need any link with a
device? What we have today is sufficient and can continue to be
supported. A link to a device is only used if the led is associated
with a particular device.
Rob
