On 11/12/18 12:58 AM, Evan Green wrote: > Update the device tree bindings for the QMP PHY to properly > specify the registers for dual-lane PHYs. Update the driver to use > those new registers. Add the DT nodes for UFS on SDM845 and MTP. > Finally, fix up the USB3 PHY on SDM845, which also has a dual-lane phy > > This series is now based on phy/next, and given that the changes stack, > I guess that means Kishon will take the whole thing? No. I'll take only the phy changes. The dts changes can probably be taken by Andy during the early 4.21 -rc cycle. Thanks Kishon > > Changes in v7: > - Rebased on top of phy/next > > Changes in v6: > - Removed resets and reset-names (Bjorn) > - Renamed nodes (Bjorn) > - Fix renamed nodes in MTP (Bjorn) > > Changes in v5: > - Fix incorrect register value in example, copied from real life! > > Changes in v4: > - Remove "status" from DT binding example (Rob) > > Changes in v3: > - Removed erroneous fixup for USB UniPro PHY, which is not dual lane (Doug) > > Changes in v2: > - Added dt bindings change, corresponding driver fixup, and USB PHY fixup > - Renamed ufsphy to phy (Vivek) > - Removed #clock-cells (Vivek) > > Can Guo (1): > arm64: dts: qcom: sdm845: Add UFS nodes for sdm845-mtp > > Evan Green (4): > dt-bindings: phy-qcom-qmp: Fix register underspecification > phy: qcom-qmp: Utilize fully-specified DT registers > arm64: dts: qcom: sdm845: add UFS controller > arm64: dts: qcom: sdm845: Add USB PHY lane two > > .../devicetree/bindings/phy/qcom-qmp-phy.txt | 69 +++++++++++++++++-- > arch/arm64/boot/dts/qcom/sdm845-mtp.dts | 14 ++++ > arch/arm64/boot/dts/qcom/sdm845.dtsi | 68 +++++++++++++++++- > drivers/phy/qualcomm/phy-qcom-qmp.c | 51 ++++++++++---- > 4 files changed, 181 insertions(+), 21 deletions(-) >
