There are many SoCs that can have different operating points supported depending on different conditions even for otherwise identical parts. It does not make sense to define many different iterations of a device tree file for each possible permutation of the same device especially when this data may exist within the part. This proposal introduces a framework and example driver to help in enabling or disabling appropriate OPPs based on a register value. The information needed for deciding which OPPs are to be enabled is defined in the device tree in a table so that one device tree file is able to support any version of the part. This series is mostly untested besides 335x and only is intended to demonstrate the approach for dynamically changing available OPPs. The framework allows other drivers to register themselves and then through a single function call modify which OPPs are available for a device. The included opp-modifier-reg driver can already support many different SoCs that have a manufacturer modifiable register defining which OPPs are possible on the SoC. This series includes example entries for am335x, am437x, omap4, dra7, and imx6q. The opp-modifier-reg driver expects all possible OPPs to be loaded for the device already and then is able to modify the table based on the details passed compared to the defined register. This RFC only applies to MPU OPPs and only supports modifying the OPP list to contain supported OPPs during boot but this driver could easily be extended to support modifying the OPPs of other IPs that have them easily by placing the hook (in patch 3 here) elsewhere. The hook for opp-modifier was placed in its current only as a proof of concept; if there is a better location it should be moved. This series is tested on am33xx but must be used with 2.x+ silicon as the earlier revision does not support the same OPPs. Also for the additional OPPs the maximum voltage supplied by the regulator for the MPU rail on both am335 and am437x would need to be extended but those patches were left out of this series to focus on opp-modifier. Comments? Is this a reasonable direction to take? Dave Gerlach (9): opp-modifier: Introduce OPP Modifier Framework opp-modifier: Add opp-modifier-reg driver PM / OPP: Add hook to modify OPPs after they are loaded. ARM: dts: AM33XX: Add opp-modifier device entry and add higher OPPs ARM: dts: AM4372: Add opp-modifier device entry and add higher OPPs ARM: dts: omap443x: Add opp-modifier entry and add higher OPPs ARM: dts: omap4460: Add opp-modifier entry and add higher OPPs ARM: dts: dra7: Add opp-modifier device entry and add higher OPPs ARM: dts: imx6q: Add opp-modifier device entry .../devicetree/bindings/power/opp-modifier.txt | 111 +++++++++ arch/arm/boot/dts/am33xx.dtsi | 27 ++- arch/arm/boot/dts/am4372.dtsi | 30 +++ arch/arm/boot/dts/dra7.dtsi | 18 ++ arch/arm/boot/dts/imx6q.dtsi | 18 ++ arch/arm/boot/dts/omap443x.dtsi | 16 ++ arch/arm/boot/dts/omap4460.dtsi | 17 ++ drivers/base/power/opp.c | 8 + drivers/power/Makefile | 2 + drivers/power/opp/Makefile | 2 + drivers/power/opp/core.c | 126 ++++++++++ drivers/power/opp/opp-modifier-reg.c | 259 +++++++++++++++++++++ include/dt-bindings/opp/imx.h | 17 ++ include/dt-bindings/opp/ti.h | 33 +++ include/linux/opp-modifier.h | 35 +++ 15 files changed, 717 insertions(+), 2 deletions(-) create mode 100644 Documentation/devicetree/bindings/power/opp-modifier.txt create mode 100644 drivers/power/opp/Makefile create mode 100644 drivers/power/opp/core.c create mode 100644 drivers/power/opp/opp-modifier-reg.c create mode 100644 include/dt-bindings/opp/imx.h create mode 100644 include/dt-bindings/opp/ti.h create mode 100644 include/linux/opp-modifier.h -- 1.9.0 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
