This series adds the nodes for one of the two SD host controllers on SDM845, and wires it up on the MTP. Though I tested similar changes on another board, I was unable to actually run this on an MTP. If someone felt like trying this out on an MTP I would be grateful. The original downstream nodes had sleep pinctrl states. It's not obvious to me that all this messing with drive-strength saves non-negligible amounts of power, so I didn't add them and figured we could add them later if needed. Changes in v2: - Reworded commit message to note that there are multiple SD controllers. - Fixed alphabetization of node placement in sdm845-mtp.dtsi (Doug) - Fixed card detect name to match schematics (Doug). - Moved comment about drive strength next to the drive-strength entry (Doug) - Removed drive-strength from card detect input pin (Doug). - Consolidated tlmm nodes in MTP. Evan Green (3): dt-bindings: mmc: sdhci-msm: Clarify register requirements arm64: dts: qcom: sdm845: Add SD node arm64: dts: qcom: sdm845: Add SD nodes for sdm845-mtp .../devicetree/bindings/mmc/sdhci-msm.txt | 2 +- arch/arm64/boot/dts/qcom/sdm845-mtp.dts | 58 ++++++++++++++++++- arch/arm64/boot/dts/qcom/sdm845.dtsi | 15 +++++ 3 files changed, 72 insertions(+), 3 deletions(-) -- 2.18.1
