On Thu, 6 Dec 2018 04:20:26 +0000 Yogesh Narayan Gaur <yogeshnarayan.gaur@xxxxxxx> wrote: > Hi Boris, > > > -----Original Message----- > > From: Boris Brezillon [mailto:boris.brezillon@xxxxxxxxxxx] > > Sent: Wednesday, December 5, 2018 6:16 PM > > To: Vignesh R <vigneshr@xxxxxx>; broonie@xxxxxxxxxx > > Cc: Yogesh Narayan Gaur <yogeshnarayan.gaur@xxxxxxx>; linux- > > mtd@xxxxxxxxxxxxxxxxxxx; marek.vasut@xxxxxxxxx; linux-spi@xxxxxxxxxxxxxxx; > > devicetree@xxxxxxxxxxxxxxx; robh@xxxxxxxxxx; mark.rutland@xxxxxxx; > > shawnguo@xxxxxxxxxx; linux-arm-kernel@xxxxxxxxxxxxxxxxxxx; > > computersforpeace@xxxxxxxxx; frieder.schrempf@xxxxxxxxx; linux- > > kernel@xxxxxxxxxxxxxxx > > Subject: Re: [PATCH v5 0/7] spi: add support for octal mode > > > > On Wed, 5 Dec 2018 17:25:12 +0530 > > Vignesh R <vigneshr@xxxxxx> wrote: > > > > > >> mtd: spi-nor: add opcodes for octal Read/Write commands > > > >> mtd: spi-nor: add octal read flag for flash mt35xu512aba > > > > > > Could you consider merging these two patches alone for v4.21? > > > These can be applied independent of other patches in the series and > > > would allow supporting OSPI flash at SPI NOR level with Cadence QSPI driver. > > > > Yep, I'll queue them to spi-nor/next. > > > > > >> spi: nxp-fspi: add octal mode flag bit for octal support > > > > Mark, I think you can pick this one too. > > This patch is dependent on the series [1] which is yet to be applied by you, please apply. By me? I can't apply SPI patches.
