The clock output section for this binding describes the two outputs in the descriptions for both the #clock-cells and clock-output-names properties. Instead of overlapping information that is hard to read, rewrite the clock outputs as a list of indices and descriptions. The properies can reference this list instead. This will also make it easier to add notes or conditions to the clocks, and also for adding new outputs. Acked-by: Maxime Ripard <maxime.ripard@xxxxxxxxxxx> Tested-by: Corentin Labbe <clabbe.montjoie@xxxxxxxxx> Signed-off-by: Chen-Yu Tsai <wens@xxxxxxxx> --- Documentation/devicetree/bindings/rtc/sun6i-rtc.txt | 10 ++++++---- 1 file changed, 6 insertions(+), 4 deletions(-) diff --git a/Documentation/devicetree/bindings/rtc/sun6i-rtc.txt b/Documentation/devicetree/bindings/rtc/sun6i-rtc.txt index cf4177f61ace..fed0d58cbfec 100644 --- a/Documentation/devicetree/bindings/rtc/sun6i-rtc.txt +++ b/Documentation/devicetree/bindings/rtc/sun6i-rtc.txt @@ -10,10 +10,12 @@ Required properties: Required properties for new device trees - clocks : phandle to the 32kHz external oscillator -- clock-output-names : names of the LOSC and its external output clocks created -- #clock-cells : must be equals to 1. The RTC provides two clocks: the - LOSC and its external output, with index 0 and 1 - respectively. +- clock-output-names : names of the two clock outputs. See below. +- #clock-cells : must be equal to 1. + +The RTC provides the following clocks at the given indices: +- 0: LOSC +- 1: LOSC external output, known as X32KFOUT in the datasheet. Example: -- 2.20.0.rc1
