Guenter had some minor changes to patch #2, which I've done in this
version.
Eric Anholt (5):
dt-bindings: soc: Add a new binding for the BCM2835 PM node.
bcm2835-pm: Move bcm2835-watchdog's DT probe to an MFD.
soc: bcm: bcm2835-pm: Add support for power domains under a new
binding.
ARM: bcm283x: Extend the WDT DT node out to cover the whole PM block.
ARM: bcm283x: Switch V3D over to using the PM driver instead of
firmware.
.../bindings/soc/bcm/brcm,bcm2835-pm.txt | 42 ++
arch/arm/boot/dts/bcm2835-rpi.dtsi | 4 -
arch/arm/boot/dts/bcm283x.dtsi | 16 +-
arch/arm/mach-bcm/Kconfig | 1 +
drivers/mfd/Makefile | 1 +
drivers/mfd/bcm2835-pm.c | 92 +++
drivers/soc/bcm/Kconfig | 11 +
drivers/soc/bcm/Makefile | 1 +
drivers/soc/bcm/bcm2835-power.c | 661 ++++++++++++++++++
drivers/watchdog/bcm2835_wdt.c | 26 +-
include/dt-bindings/soc/bcm2835-pm.h | 28 +
include/linux/mfd/bcm2835-pm.h | 14 +
12 files changed, 873 insertions(+), 24 deletions(-)
create mode 100644 Documentation/devicetree/bindings/soc/bcm/brcm,bcm2835-pm.txt
create mode 100644 drivers/mfd/bcm2835-pm.c
create mode 100644 drivers/soc/bcm/bcm2835-power.c
create mode 100644 include/dt-bindings/soc/bcm2835-pm.h
create mode 100644 include/linux/mfd/bcm2835-pm.h
--
2.20.0.rc1
