While doing Bluetooth enablement for various boards based on various Allwinner SoCs, minor differences in the RTC modules were found. These include a lack of an external clock output (A31), different internal oscillator frequencies (H3/H5/A64/V3/V3s), different regulator voltage settings (H5/H6), and the presence of miscellaneous registers unrelated to the RTC (A64/R40/H5/H6). The datasheet also describes different number of registers for non-volatile storage, though based on actual experiments the actual number is the same across the board. This patch adds a list of all pre-H6 variants, grouped by the internal oscillator's clock rate, regulator settings, and the presence of the external clock output. Combinations are introduced for the variants that have miscellaneous registers. The RTC block in the H6 also handles the 24 MHz DCXO. This will require more device tree binding changes and will be done later. Signed-off-by: Chen-Yu Tsai <wens@xxxxxxxx> --- .../devicetree/bindings/rtc/sun6i-rtc.txt | 16 +++++++++++++++- 1 file changed, 15 insertions(+), 1 deletion(-) diff --git a/Documentation/devicetree/bindings/rtc/sun6i-rtc.txt b/Documentation/devicetree/bindings/rtc/sun6i-rtc.txt index d3e96459fc66..b1eaa443347d 100644 --- a/Documentation/devicetree/bindings/rtc/sun6i-rtc.txt +++ b/Documentation/devicetree/bindings/rtc/sun6i-rtc.txt @@ -3,7 +3,21 @@ RTC controller for the Allwinner A31 Required properties: -- compatible : Should be "allwinner,sun6i-a31-rtc" +- compatible : Should be one of the following combinations: + - "allwinner,sun6i-a31-rtc" + - "allwinner,sun8i-a23-rtc" + - "allwinner,sun8i-h3-rtc" + - "allwinner,sun8i-r40-rtc", "allwinner,sun8i-h3-rtc" + - "allwinner,sun8i-v3-rtc" + - "allwinner,sun50i-a64-rtc", "allwinner,sun8i-h3-rtc" + - "allwinner,sun50i-h5-rtc" + + Where there are two or more compatible strings, this + denotes the hardware covered by the most specific one + is backward-compatible with the latter ones, and the + implementation for the latter ones can be used, albeit + with reduced functionality. + - reg : physical base address of the controller and length of memory mapped region. - interrupts : IRQ lines for the RTC alarm 0 and alarm 1, in that order. -- 2.20.0.rc1
