On Mon, Nov 26, 2018 at 05:27:50PM +0200, Priit Laes wrote:
> In the defense of LDO3, LDO3 is the regulator that feeds port bank E,
> which has no other purpose then a CSI/TS interface, however the case
> may still be, that the connected IO may be just as well be 3.3 volts.
> The big misnomer is however, that the schematic names GPIO-2 pin4
> LDO3_2.8V, rather then VDD-CSI0 or similar.
In general you want to run regulators at the lowest voltage you can,
this tends to reduce power consumption.
> Ideally, we want to set a supply voltage for each port bank, but the
> monolithic nature of the sunxi pinctroller currently prevents this and
> as such, the board should at least configure the LDO4 with the proper
> ranges.
> ®_ldo4 {
> - regulator-min-microvolt = <2800000>;
> - regulator-max-microvolt = <2800000>;
> - regulator-name = "vddio-csi1";
> + regulator-always-on;
> + regulator-min-microvolt = <1250000>;
> + regulator-max-microvolt = <3300000>;
> + regulator-name = "vdd-io-pg";
> };
This is obviously broken even according to your analysis above - if you
have consumers for which 2.8V is too low allowing other consumers to set
even lower voltages is not going to help as soon as they start doing
that.
Attachment:
signature.asc
Description: PGP signature
