The datasheet uses the name "All Mask" for this bit. Change the name of
our #define to be consistent with the datasheet. While here also replace
the tab between the #define and IP101A_G_IRQ_ALL_MASK with a space.
No functional changes.
Signed-off-by: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx>
Reviewed-by: Andrew Lunn <andrew@xxxxxxx>
---
drivers/net/phy/icplus.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/net/phy/icplus.c b/drivers/net/phy/icplus.c
index 3ec470adde3d..c9489ec77cef 100644
--- a/drivers/net/phy/icplus.c
+++ b/drivers/net/phy/icplus.c
@@ -43,7 +43,7 @@ MODULE_LICENSE("GPL");
#define IP101A_G_APS_ON BIT(1) /* IP101A/G APS Mode bit */
#define IP101A_G_IRQ_CONF_STATUS 0x11 /* Conf Info IRQ & Status Reg */
#define IP101A_G_IRQ_PIN_USED BIT(15) /* INTR pin used */
-#define IP101A_G_NO_IRQ BIT(11) /* IRQ's inactive */
+#define IP101A_G_IRQ_ALL_MASK BIT(11) /* IRQ's inactive */
static int ip175c_config_init(struct phy_device *phydev)
{
@@ -204,7 +204,7 @@ static int ip101a_g_config_intr(struct phy_device *phydev)
/* INTR pin used: Speed/link/duplex will cause an interrupt */
val = IP101A_G_IRQ_PIN_USED;
else
- val = IP101A_G_NO_IRQ;
+ val = IP101A_G_IRQ_ALL_MASK;
return phy_write(phydev, IP101A_G_IRQ_CONF_STATUS, val);
}
--
2.19.1
