Commit "4adb0a0432f4 media: ov5645: Supported external clock is 24MHz" modified the external clock frequency to be 24MHz instead of the 23.88MHz in driver. Hence, make the same change in corresponding bindings doc and mention the acceptable tolerance. Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx> --- Documentation/devicetree/bindings/media/i2c/ov5645.txt | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-) diff --git a/Documentation/devicetree/bindings/media/i2c/ov5645.txt b/Documentation/devicetree/bindings/media/i2c/ov5645.txt index fd7aec9f8e24..b155583469a4 100644 --- a/Documentation/devicetree/bindings/media/i2c/ov5645.txt +++ b/Documentation/devicetree/bindings/media/i2c/ov5645.txt @@ -8,7 +8,8 @@ Required Properties: - compatible: Value should be "ovti,ov5645". - clocks: Reference to the xclk clock. - clock-names: Should be "xclk". -- clock-frequency: Frequency of the xclk clock. +- clock-frequency: Frequency of the xclk clock. Should be 24MHz with 1% + acceptable tolerance. - enable-gpios: Chip enable GPIO. Polarity is GPIO_ACTIVE_HIGH. This corresponds to the hardware pin PWDNB which is physically active low. - reset-gpios: Chip reset GPIO. Polarity is GPIO_ACTIVE_LOW. This corresponds to @@ -37,7 +38,7 @@ Example: clocks = <&clks 200>; clock-names = "xclk"; - clock-frequency = <23880000>; + clock-frequency = <24000000>; vdddo-supply = <&camera_dovdd_1v8>; vdda-supply = <&camera_avdd_2v8>; -- 2.17.1
