From: Heiko Stuebner <heiko.stuebner@xxxxxx>
Similar to gpio-reset allow to specify active and inactive delays
while keeping the 100ms defaults that were used previously all the time.
The dt-properties are named the same as in gpio-reset but get an "-ms"
suffix as properties should contain such a suffix specifying its unit.
Signed-off-by: Heiko Stuebner <heiko.stuebner@xxxxxx>
---
.../devicetree/bindings/power/reset/gpio-poweroff.txt | 2 ++
drivers/power/reset/gpio-poweroff.c | 10 ++++++++--
2 files changed, 10 insertions(+), 2 deletions(-)
diff --git a/Documentation/devicetree/bindings/power/reset/gpio-poweroff.txt b/Documentation/devicetree/bindings/power/reset/gpio-poweroff.txt
index 6d8980c18c34..3e56c1b34a4c 100644
--- a/Documentation/devicetree/bindings/power/reset/gpio-poweroff.txt
+++ b/Documentation/devicetree/bindings/power/reset/gpio-poweroff.txt
@@ -27,6 +27,8 @@ Optional properties:
it to an output when the power-off handler is called. If this optional
property is not specified, the GPIO is initialized as an output in its
inactive state.
+- active-delay-ms: Delay (default 100) to wait after driving gpio active
+- inactive-delay-ms: Delay (default 100) to wait after driving gpio inactive
- timeout-ms: Time to wait before asserting a WARN_ON(1). If nothing is
specified, 3000 ms is used.
diff --git a/drivers/power/reset/gpio-poweroff.c b/drivers/power/reset/gpio-poweroff.c
index 38206c39b3bf..52525b6c18db 100644
--- a/drivers/power/reset/gpio-poweroff.c
+++ b/drivers/power/reset/gpio-poweroff.c
@@ -26,6 +26,8 @@
*/
static struct gpio_desc *reset_gpio;
static u32 timeout = DEFAULT_TIMEOUT_MS;
+static u32 active_delay = 100;
+static u32 inactive_delay = 100;
static void gpio_poweroff_do_poweroff(void)
{
@@ -33,10 +35,11 @@ static void gpio_poweroff_do_poweroff(void)
/* drive it active, also inactive->active edge */
gpiod_direction_output(reset_gpio, 1);
- mdelay(100);
+ mdelay(active_delay);
+
/* drive inactive, also active->inactive edge */
gpiod_set_value_cansleep(reset_gpio, 0);
- mdelay(100);
+ mdelay(inactive_delay);
/* drive it active, also inactive->active edge */
gpiod_set_value_cansleep(reset_gpio, 1);
@@ -66,6 +69,9 @@ static int gpio_poweroff_probe(struct platform_device *pdev)
else
flags = GPIOD_OUT_LOW;
+ device_property_read_u32(&pdev->dev, "active-delay-ms", &active_delay);
+ device_property_read_u32(&pdev->dev, "inactive-delay-ms",
+ &inactive_delay);
device_property_read_u32(&pdev->dev, "timeout-ms", &timeout);
reset_gpio = devm_gpiod_get(&pdev->dev, NULL, flags);
--
2.18.0
