Hi Anson, On Wed, Nov 7, 2018 at 11:24 PM Anson Huang <anson.huang@xxxxxxx> wrote: > Regarding the fec2 settings in imx7d-sdb.dts, originally it uses Rev-A board (but some nodes are > using Rev-B board), in this patch, I clean up all the settings in imx7d-sdb.dts using Rev-B board, > so below is added to imx7d-sdb.dts for Rev-B board, and in imx7d-sdb-reva.dts I have to > delete it, since Rev-A board has no this pin. > > - pinctrl-0 = <&pinctrl_enet2>; > + pinctrl-0 = <&pinctrl_enet2 &pinctrl_enet2_epdc0_en>; > + pinctrl-assert-gpios = <&gpio1 4 GPIO_ACTIVE_LOW>; "pinctrl-assert-gpios" only exists in the NXP vendor kernel, so you cannot use such property in mainline.
