[PATCH 10/15] Bluetooth: hci_bcm: Wait for device to come out of reset after power on

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



The datasheets for BCM20702 and BCM43438 both have power up time
sequence graphs, however they are slightly different. Both chips
also have an internal power-on-reset, which holds the chip in reset
for a short time after the regulators are enabled.

For the BCM20702, the time period from when the regulators are enabled,
until the chip settles and comes out of sleep state, is 6564 ~ 8171 us.

For the BCM43438, the graph only shows the time period from when the
regulators are enabled until the chip responds by driving the host's
CTS line low, assuming the host has already driven its RTS line low.
This is shown to be 6.5 sleep cycles, with the sleep clock at 32.768
kHz. This is around 2 ms.

Wait a full 10 ms after the regulators are enabled to account for signal
rising times.

Signed-off-by: Chen-Yu Tsai <wens@xxxxxxxx>
---
 drivers/bluetooth/hci_bcm.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/drivers/bluetooth/hci_bcm.c b/drivers/bluetooth/hci_bcm.c
index 060001f11a98..bf5dee9b04d8 100644
--- a/drivers/bluetooth/hci_bcm.c
+++ b/drivers/bluetooth/hci_bcm.c
@@ -256,6 +256,9 @@ static int bcm_gpio_set_power(struct bcm_device *dev, bool powered)
 		regulator_bulk_disable(BCM_NUM_SUPPLIES, dev->supplies);
 	}
 
+	/* wait for device to power on and come out of reset */
+	usleep_range(10000, 20000);
+
 	dev->res_enabled = powered;
 
 	return 0;
-- 
2.19.1




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux