On Tue, Nov 6, 2018 at 8:46 AM Sven Van Asbroeck <thesven73@xxxxxxxxx> wrote:
>
> On Tue, Nov 6, 2018 at 8:58 AM Rob Herring <robh@xxxxxxxxxx> wrote:
>
> > It doesn't really sound like the host should be in DT. The bridge
> > should register itself as an anybus provider and that should in turn
> > enable the anybus host protocol.
>
> Very good point. Just to make sure we're on the same page, could you point
> me to a relevant example where something registers as a provider?
Not sure exactly. Perhaps I2C SMBus functions that implement the
register access protocol on top of I2C bus.
> v1 of this patch did not have the host in DT. The host just required platform
> data with a regmap and a reset (the interrupt was passed via resources):
>
> struct anybuss_host_pdata {
> struct regmap *regmap;
> void (*reset)(struct device *dev, bool reset);
> };
>
> But there were problems with this approach.
A block diagram would help. Something that shows the host SoC, your
CPLD, reset, irq, etc.
> The review feedback told me that my self-rolled reset callback should really
> be a reset controller. I looked for ways to pass a handle to a reset controller
> via platform data. This has recently been introduced via:
Maybe an overkill for 1 reset.
>
> reset_controller_add_lookup()
>
> This binds a client device to a reset controller, without using the devicetree,
> so the device can grab its controller via (devm_)reset_control_get*. Great!
> But... to make the binding, you have to specify the full device names of the
> controllers and client devices. See this example from psc-da850.c:
>
> static struct reset_control_lookup da850_psc0_reset_lookup_table[] = {
> RESET_LOOKUP("da850-psc0", 15, "davinci-rproc.0", NULL),
> };
>
> I very quickly found myself in ida_simple_get() hell, trying to second-guess
> what the devices I was creating, would be called !
>
> So instead I put the host in DT, then I could easily connect the reset
> controller. This also greatly simplified the bridge driver, a lot of boilerplate
> would simply disappear.
If the host is not a h/w component, but just a s/w protocol then it
doesn't belong in DT. Perhaps it could be a library which the bridge
driver can call into.
What are the resets connected to? The slots? Maybe you should model
the slots in DT.
Rob
