Lokesh, On 10/29/18 3:04 PM, Lokesh Vutla wrote: >>> With the above information, linux should send a message to >>> system-controller using TISCI protocol. After policing the given >>> information, system-controller does the following: >>> - Attaches the interrupt(INTA input) to the device resource index >>> - Muxes the interrupt(INTA input) to corresponding vint(INTA output) >>> - Muxes the vint(INTR input) to GIC irq(INTR output). >> >> Isn't there a 1:1 mapping between *used* INTR inputs and outputs? >> Since INTR is a router, there is no real muxing. I assume that the >> third point above is just a copy-paste error. > > Right, my bad. INTR is just a router and no read muxing. INTR can mux M interrupt inputs to N interrupt outputs. One selects which interrupt input is outputted on the given interrupt output. It is perfectly valid (but not sane) to select the same interrupt input to be routed to _all_ interrupt output for example. Not sure if we are going to use this for anything but 1:1 mapping, but might worth keeping in mind... - Peter Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki. Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki
