On 10/11/2018 08:34 PM, Dan Murphy wrote: > Pavel > > On 10/11/2018 01:27 PM, Pavel Machek wrote: >> On Thu 2018-10-11 11:51:16, Dan Murphy wrote: >>> Remove support for the LM3697 LED device >>> from the ti-lmu. The LM3697 will be supported >>> via a stand alone LED driver. >>> >>> Signed-off-by: Dan Murphy <dmurphy@xxxxxx> >> >> NAK. > > Thanks for the NAK. > > This NAK was NAK'd by other maintainer in the V2 RFC patchset > > https://lore.kernel.org/patchwork/patch/993171/ I confirm. LM3697 is a standalone device and not a cell of any MFD device. Waiting for DT maintainer's ack. Best regards, Jacek Anaszewski >>> index c885cf89b8ce..920f910be4e9 100644 >>> --- a/Documentation/devicetree/bindings/mfd/ti-lmu.txt >>> +++ b/Documentation/devicetree/bindings/mfd/ti-lmu.txt >>> @@ -9,7 +9,6 @@ TI LMU driver supports lighting devices below. >>> LM3632 Backlight and regulator >>> LM3633 Backlight, LED and fault monitor >>> LM3695 Backlight >>> - LM3697 Backlight and fault monitor >>> >>> Required properties: >>> - compatible: Should be one of: >>> @@ -18,11 +17,10 @@ Required properties: >>> "ti,lm3632" >>> "ti,lm3633" >>> "ti,lm3695" >>> - "ti,lm3697" >>> - reg: I2C slave address. >>> 0x11 for LM3632 >>> 0x29 for LM3631 >>> - 0x36 for LM3633, LM3697 >>> + 0x36 for LM3633 >>> 0x38 for LM3532 >>> 0x63 for LM3695 >>> >>> @@ -38,7 +36,6 @@ Optional nodes: >>> Required properties: >>> - compatible: Should be one of: >>> "ti,lm3633-fault-monitor" >>> - "ti,lm3697-fault-monitor" >>> - leds: LED properties for LM3633. Please refer to [2]. >>> - regulators: Regulator properties for LM3631 and LM3632. >>> Please refer to [3]. >>> @@ -220,24 +217,3 @@ lm3695@63 { >>> }; >>> }; >>> }; >>> - >>> -lm3697@36 { >>> - compatible = "ti,lm3697"; >>> - reg = <0x36>; >>> - >>> - enable-gpios = <&pioC 2 GPIO_ACTIVE_HIGH>; >>> - >>> - backlight { >>> - compatible = "ti,lm3697-backlight"; >>> - >>> - lcd { >>> - led-sources = <0 1 2>; >>> - ramp-up-msec = <200>; >>> - ramp-down-msec = <200>; >>> - }; >>> - }; >>> - >>> - fault-monitor { >>> - compatible = "ti,lm3697-fault-monitor"; >>> - }; >>> -}; >> > >
