From: Dilip Kota <dkota@xxxxxxxxxxxxxx> SPI controller driver should maintain the maximum frequency of the controller instead of relying on device tree bindings. Because maximum frequency is specific property of SPI controller. Signed-off-by: Dilip Kota <dkota@xxxxxxxxxxxxxx> Reviewed-by: Douglas Anderson <dianders@xxxxxxxxxxxx> Reviewed-by: Stephen Boyd <swboyd@xxxxxxxxxxxx> Reviewed-by: Rob Herring <robh@xxxxxxxxxx> Signed-off-by: Alok Chauhan <alokc@xxxxxxxxxxxxxx> --- Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt | 2 -- 1 file changed, 2 deletions(-) diff --git a/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt b/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt index ff92e5a..b9d0c21 100644 --- a/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt +++ b/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt @@ -60,7 +60,6 @@ Required properties: - interrupts: Must contain SPI controller interrupts. - clock-names: Must contain "se". - clocks: Serial engine core clock needed by the device. -- spi-max-frequency: Specifies maximum SPI clock frequency, units - Hz. - #address-cells: Must be <1> to define a chip select address on the SPI bus. - #size-cells: Must be <0>. @@ -112,7 +111,6 @@ Example: pinctrl-names = "default", "sleep"; pinctrl-0 = <&qup_1_spi_2_active>; pinctrl-1 = <&qup_1_spi_2_sleep>; - spi-max-frequency = <19200000>; #address-cells = <1>; #size-cells = <0>; }; -- The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project
