Hi Ricardo,
Thank you for the patch.
On Tuesday, 2 October 2018 14:13:56 EEST Ricardo Ribalda Delgado wrote:
> Document new enable-gpio field. It can be used to disable the part
> without turning down its regulator.
>
> Cc: devicetree@xxxxxxxxxxxxxxx
> Signed-off-by: Ricardo Ribalda Delgado <ricardo.ribalda@xxxxxxxxx>
> Acked-by: Pavel Machek <pavel@xxxxxx>
Reviewed-by: Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx>
> ---
> Documentation/devicetree/bindings/media/i2c/ad5820.txt | 6 ++++++
> 1 file changed, 6 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/media/i2c/ad5820.txt
> b/Documentation/devicetree/bindings/media/i2c/ad5820.txt index
> 5940ca11c021..db596e8eb0ba 100644
> --- a/Documentation/devicetree/bindings/media/i2c/ad5820.txt
> +++ b/Documentation/devicetree/bindings/media/i2c/ad5820.txt
> @@ -8,6 +8,11 @@ Required Properties:
>
> - VANA-supply: supply of voltage for VANA pin
>
> +Optional properties:
> +
> + - enable-gpios : GPIO spec for the XSHUTDOWN pin. The XSHUTDOWN signal
> is +active low, a high level on the pin enables the device.
> +
> Example:
>
> ad5820: coil@c {
> @@ -15,5 +20,6 @@ Example:
> reg = <0x0c>;
>
> VANA-supply = <&vaux4>;
> + enable-gpios = <&msmgpio 26 GPIO_ACTIVE_HIGH>;
> };
--
Regards,
Laurent Pinchart
