On Thu, Sep 27, 2018 at 05:18:45PM +0530, Jagan Teki wrote:
> TCON DRQ set bits for non-burst DSI mode can computed via
> horizontal front porch instead of front porch + sync timings.
>
> Since there no documentation for TCON_DRQ_REG(0x7c) register
> this change is taken as reference from BPI-M64-bsp.
Detailing more what the issue is would be great.
> Signed-off-by: Jagan Teki <jagan@xxxxxxxxxxxxxxxxxxxx>
> ---
> drivers/gpu/drm/sun4i/sun6i_mipi_dsi.c | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/gpu/drm/sun4i/sun6i_mipi_dsi.c b/drivers/gpu/drm/sun4i/sun6i_mipi_dsi.c
> index 599284971ab6..9918fdb990ff 100644
> --- a/drivers/gpu/drm/sun4i/sun6i_mipi_dsi.c
> +++ b/drivers/gpu/drm/sun4i/sun6i_mipi_dsi.c
> @@ -367,9 +367,9 @@ static void sun6i_dsi_setup_burst(struct sun6i_dsi *dsi,
> struct mipi_dsi_device *device = dsi->device;
> u32 val = 0;
The computation here is in the A64 driver:
if ((panel->lcd_ht - panel->lcd_x - panel->lcd_hbp) < 21) {
dsi_dev[sel]->dsi_tcon_drq.bits.drq_mode = 0;
} else {
dsi_dev[sel]->dsi_tcon_drq.bits.drq_set =
(panel->lcd_ht-panel->lcd_x-panel->lcd_hbp-20) *
dsi_pixel_bits[panel->lcd_dsi_format]/(8*4);
}
It is testing that the sync + front porch is smaller than 21, and
otherwise sets the drq.
> - if ((mode->hsync_end - mode->hdisplay) > 20) {
My code here is testing that the difference between hsync_end and
hdisplay is superior to 20, and sets the DRQ if true. The condition is
reversed, but otherwise, that difference is the front porch plus the
sync length.
> + if ((mode->hsync_start - mode->hdisplay) > 20) {
However, you are testing for just the front porch, unlike what your
commit log is saying, and unlike what allwinner's code is saying. So
this deserves some explanation.
Maxime
--
Maxime Ripard, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com
