Re: [PATCH v3 2/2] hwmon: ina3221: Read channel input source info from DT

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 09/22/2018 08:33 PM, Nicolin Chen wrote:

No. If the chip was configured by the BIOS/ROMMON, it is supposed
to be that way. We can not just override that.

For this driver, it does soft reset in the probe() so we're
sure that all channels are enabled at the moment of calling
this regmap_update_bits. So there's no assumption anymore.


Good point.

But the case that you mentioned is a good one. It does give
me some insight about the use case and the things that will
need to be careful when adding in[123]_enable. Just it'd be
also possible that BIOS could disable a channel that is not
explicitly disabled in the DT -- then the driver should not
enable it.


Not necessarily. Again, we can not assume that everyone has DT
(or that it and/or the BIOS is correct, for that matter).

Nevertheless, adding the enable attribute is not required at this
point, so it is ok for me to skip it. Please note that I'll accept
a patch adding it, though, if it is ever submitted (with a use case).

Thanks,
Guenter



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux