Hi Phillip,
On 03/06/2014 07:08 PM, Philipp Zabel wrote:
+++ b/Documentation/devicetree/bindings/media/samsung-s5k6a3.txt
> @@ -0,0 +1,33 @@
> +Samsung S5K6A3(YX) raw image sensor
> +---------------------------------
> +
> +S5K6A3(YX) is a raw image sensor with MIPI CSI-2 and CCP2 image data interfaces
> +and CCI (I2C compatible) control bus.
> +
> +Required properties:
> +
> +- compatible : "samsung,s5k6a3";
> +- reg : I2C slave address of the sensor;
> +- svdda-supply : core voltage supply;
> +- svddio-supply : I/O voltage supply;
> +- afvdd-supply : AF (actuator) voltage supply;
> +- gpios : specifier of a GPIO connected to the RESET pin;
Please use 'reset-gpios' for GPIOs connected to reset pins.
I would prefer to keep it as is, I'm not adding a new driver in this
series, just the binding documentation and doing some refactoring.
So if I changed this now, the driver would need to be messed up with
an additional code to support both 'gpios' and 'reset-gpios'. Are
there any serious reasons to use this specific name ? It's not
related to the reset signal DT bindings, is it ?
--
Regards,
Sylwester
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
