Hi Robin, On 19.09.2018 16:41, Robin Murphy wrote: > On 19/09/18 13:36, laurentiu.tudor@xxxxxxx wrote: >> From: Laurentiu Tudor <laurentiu.tudor@xxxxxxx> >> >> The StreamID entering the SMMU is actually a concatenation of the >> SMMU TBU ID and the ICID configured in software. >> Since the TBU ID is internal to the SoC and since we want that the >> actual the ICID configured in software to enter the SMMU witout any >> additional set bits, mask out the TBU ID bits and leave only the >> relevant ICID bits to enter SMMU. >> >> Signed-off-by: Laurentiu Tudor <laurentiu.tudor@xxxxxxx> >> --- >> arch/arm64/boot/dts/freescale/fsl-ls1043a.dtsi | 1 + >> arch/arm64/boot/dts/freescale/fsl-ls1046a.dtsi | 1 + >> 2 files changed, 2 insertions(+) >> >> diff --git a/arch/arm64/boot/dts/freescale/fsl-ls1043a.dtsi >> b/arch/arm64/boot/dts/freescale/fsl-ls1043a.dtsi >> index 8b3eba167508..90296b9fb171 100644 >> --- a/arch/arm64/boot/dts/freescale/fsl-ls1043a.dtsi >> +++ b/arch/arm64/boot/dts/freescale/fsl-ls1043a.dtsi >> @@ -226,6 +226,7 @@ >> compatible = "arm,mmu-500"; >> reg = <0 0x9000000 0 0x400000>; >> dma-coherent; >> + stream-match-mask = <0x7f00>; > > The TBU ID only forms the top 5 bits, so also ignoring bits 9:8 raises > an eyebrow - if the LS104x SMMU really is configured for 8-bit SID input > then it's harmless, On these lower-end platforms the SID input is configured and documented as 8-bit. > but if it's actually a 9 or 10-bit configuration > then you probably want to avoid masking them (or at least document why) > - IIRC there *was* stuff wired there on LS2085 at least. Yes, on LS2s there are 2 extra-bits in there carrying some signaling. However, on LS1s they are not present. --- Thanks & Best Regards, Laurentiu > >> #global-interrupts = <2>; >> #iommu-cells = <1>; >> interrupts = <0 142 4>, /* global secure fault */ >> diff --git a/arch/arm64/boot/dts/freescale/fsl-ls1046a.dtsi >> b/arch/arm64/boot/dts/freescale/fsl-ls1046a.dtsi >> index 06863d3e4a7d..15094dd8400e 100644 >> --- a/arch/arm64/boot/dts/freescale/fsl-ls1046a.dtsi >> +++ b/arch/arm64/boot/dts/freescale/fsl-ls1046a.dtsi >> @@ -232,6 +232,7 @@ >> compatible = "arm,mmu-500"; >> reg = <0 0x9000000 0 0x400000>; >> dma-coherent; >> + stream-match-mask = <0x7f00>; >> #global-interrupts = <2>; >> #iommu-cells = <1>; >> interrupts = <0 142 4>, /* global secure fault */ >>
