Hi Sergei,
On 2018-08-06 21:24:11 +0300, Sergei Shtylyov wrote:
> Hello!
>
> On 08/06/2018 09:02 PM, Niklas Söderlund wrote:
>
> > On 2018-08-06 19:56:27 +0300, Sergei Shtylyov wrote:
> >> Add the R-Car V3H (AKA R8A77980) SoC support to the R-Car CSI2 driver.
> >>
> >> Signed-off-by: Sergei Shtylyov <sergei.shtylyov@xxxxxxxxxxxxxxxxxx>
> >
> > It looks good but before I add my tag I would like to know if you tested
> > this on a V3H?
>
> No, have not tested the upstream patch, seemed too cumbersome (we did
> test the BSP patch AFAIK).
Did you find time to test this change? I think it looks good but I would
feel a lot better about this change if I knew it was tested :-) More
often then not have we shaken a bug out of the rcar-{csi2,vin} tree by
adding support for a new SoC.
Also if you for some reason need to resend this series could you split
the DT documentation and driver changes in two separate patches?
>
> > In the past extending the R-Car CSI-2 receiver to a new
> > SoC always caught some new corner case :-)
> >
> > I don't have access to a V3H myself otherwise I would of course test it
> > myself.
>
> CSI-2 on the Condor board is connected to a pair of MAX9286 GMSL de-serializers
> which are connected to 4 (composite?) connectors... There's supposed to be sensor
> chip on the other side, AFAIK...
There is experimental patches which are tested on V3M that uses the
MAX9286 GMSL setup if you feel brave and want to try and extend them to
cover V3H ;-P
>
> MBR, Sergei
--
Regards,
Niklas Söderlund
