The commit adds the device tree binding documentation for the MediaTek
GMAC found on Mediatek MT2712.
Signed-off-by: Biao Huang <biao.huang@xxxxxxxxxxxx>
---
.../devicetree/bindings/net/mediatek-gmac.txt | 45 ++++++++++++++++++++
1 file changed, 45 insertions(+)
create mode 100644 Documentation/devicetree/bindings/net/mediatek-gmac.txt
diff --git a/Documentation/devicetree/bindings/net/mediatek-gmac.txt b/Documentation/devicetree/bindings/net/mediatek-gmac.txt
new file mode 100644
index 0000000..14876ed
--- /dev/null
+++ b/Documentation/devicetree/bindings/net/mediatek-gmac.txt
@@ -0,0 +1,45 @@
+MediaTek Gigabit Ethernet controller
+=========================================
+
+The gigabit ethernet controller can be found on MediaTek SoCs.
+
+* Ethernet controller node
+
+Required properties:
+- compatible: Should be
+ "mediatek,mt2712-eth": for MT2712 SoC
+- reg: Address and length of the register set for the device
+- interrupts: Should contain the MAC interrupts
+- interrupt-names: the name of interrupt in the interrupts property. These are
+ "macirq": For MT2712 SoC
+- clocks: the clock used by the controller
+- clock-names: the names of the clock listed in the clocks property. These are
+ "axi", "apb", "mac_ext", "ptp", "ptp_parent", "ptp_top": For MT2712 SoC
+- mac-address: See ethernet.txt in the same directory
+- power-domains: phandle to the power domain that the ethernet is part of
+- phy-mode: See ethernet.txt file in the same directory.
+- reset-gpio: gpio number for phy reset.
+
+Example:
+
+eth: eth@1101c000 {
+ compatible = "mediatek,mt2712-eth";
+ reg = <0 0x1101c000 0 0x1200>;
+ interrupts = <GIC_SPI 237 IRQ_TYPE_LEVEL_LOW>;
+ interrupt-names = "macirq";
+ phy-mode ="rgmii";
+ mac-address = [00 55 7b b5 7d f7];
+ clock-names = "axi",
+ "apb",
+ "mac_ext",
+ "ptp",
+ "ptp_parent",
+ "ptp_top";
+ clocks = <&pericfg CLK_PERI_GMAC>,
+ <&pericfg CLK_PERI_GMAC_PCLK>,
+ <&topckgen CLK_TOP_ETHER_125M_SEL>,
+ <&topckgen CLK_TOP_ETHER_50M_SEL>,
+ <&topckgen CLK_TOP_APLL1_D3>,
+ <&topckgen CLK_TOP_APLL1>;
+ reset-gpio = <&pio 87 GPIO_ACTIVE_HIGH>;
+ };
--
1.7.9.5
