On 07/09/2018 21:35:07+0200, Sam Ravnborg wrote:
> From: Søren Andersen <san@xxxxxxx>
>
> Add support for specifying the quartz load in the DT node.
> The pcf8523 may use either a 7 pF or an 12.5 pF xtal.
> If the rtc has the wrong configuration the time will
> drift several hours/week.
>
> If nothing is specified in DT then the factory default of 7 pF is used.
> This is a change compared to before where the driver assumed 12.5 pF.
>
> Note: all kernel dts trees are updated with the new property.
>
> Signed-off-by: Søren Andersen <san@xxxxxxx>
> Signed-off-by: Sam Ravnborg <sam@xxxxxxxxxxxx>
> Cc: Alessandro Zummo <a.zummo@xxxxxxxxxxxx>
> Cc: Alexandre Belloni <alexandre.belloni@xxxxxxxxxxx>
> ---
> drivers/rtc/rtc-pcf8523.c | 6 +++---
> 1 file changed, 3 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/rtc/rtc-pcf8523.c b/drivers/rtc/rtc-pcf8523.c
> index 453615f8ac9a..3c19b4d21a2d 100644
> --- a/drivers/rtc/rtc-pcf8523.c
> +++ b/drivers/rtc/rtc-pcf8523.c
> @@ -85,7 +85,7 @@ static int pcf8523_write(struct i2c_client *client, u8 reg, u8 value)
> return 0;
> }
>
> -static int pcf8523_select_capacitance(struct i2c_client *client, bool high)
> +static int pcf8523_select_capacitance(struct i2c_client *client)
> {
> u8 value;
> int err;
> @@ -94,7 +94,7 @@ static int pcf8523_select_capacitance(struct i2c_client *client, bool high)
> if (err < 0)
> return err;
>
> - if (!high)
> + if (!device_property_present(&client->dev, "nxp,quartz_load_12.5pf"))
OK, this is super annoying we unfortunately can't change what was done
previously without breaking the DT ABI. Honestly, I suspect the 12.5pF
value is wrong for most boards anyway.
What I would do is use the value from DT (so either 7000fF or 12500fF)
and set it if present.
If not present, set 12.5pF and print a warning that this differs from
the RTC default.
Hopefully, at some point, we could leave it as it is as the value should
persist across reboot.
--
Alexandre Belloni, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com
