Remove support for the LM3697 LED device from the ti-lmu. The LM3697 will be supported via a stand alone LED driver. Signed-off-by: Dan Murphy <dmurphy@xxxxxx> --- v7 - New change for the series based on the comments in https://lore.kernel.org/patchwork/patch/982550/ .../devicetree/bindings/mfd/ti-lmu.txt | 26 +------------------ 1 file changed, 1 insertion(+), 25 deletions(-) diff --git a/Documentation/devicetree/bindings/mfd/ti-lmu.txt b/Documentation/devicetree/bindings/mfd/ti-lmu.txt index c885cf89b8ce..920f910be4e9 100644 --- a/Documentation/devicetree/bindings/mfd/ti-lmu.txt +++ b/Documentation/devicetree/bindings/mfd/ti-lmu.txt @@ -9,7 +9,6 @@ TI LMU driver supports lighting devices below. LM3632 Backlight and regulator LM3633 Backlight, LED and fault monitor LM3695 Backlight - LM3697 Backlight and fault monitor Required properties: - compatible: Should be one of: @@ -18,11 +17,10 @@ Required properties: "ti,lm3632" "ti,lm3633" "ti,lm3695" - "ti,lm3697" - reg: I2C slave address. 0x11 for LM3632 0x29 for LM3631 - 0x36 for LM3633, LM3697 + 0x36 for LM3633 0x38 for LM3532 0x63 for LM3695 @@ -38,7 +36,6 @@ Optional nodes: Required properties: - compatible: Should be one of: "ti,lm3633-fault-monitor" - "ti,lm3697-fault-monitor" - leds: LED properties for LM3633. Please refer to [2]. - regulators: Regulator properties for LM3631 and LM3632. Please refer to [3]. @@ -220,24 +217,3 @@ lm3695@63 { }; }; }; - -lm3697@36 { - compatible = "ti,lm3697"; - reg = <0x36>; - - enable-gpios = <&pioC 2 GPIO_ACTIVE_HIGH>; - - backlight { - compatible = "ti,lm3697-backlight"; - - lcd { - led-sources = <0 1 2>; - ramp-up-msec = <200>; - ramp-down-msec = <200>; - }; - }; - - fault-monitor { - compatible = "ti,lm3697-fault-monitor"; - }; -}; -- 2.17.0.1855.g63749b2dea
