Am Freitag, 7. September 2018, 10:58:04 CEST schrieb Robin Murphy:
> On 2018-09-06 2:50 PM, Heiko Stuebner wrote:
> > From: Zheng Yang <zhengyang@xxxxxxxxxxxxxx>
> >
> > Add a driver for the Innosilicon hdmi phy used on rk3228/rk3229
> > and rk3328 socs from Rockchip.
> >
> > Signed-off-by: Zheng Yang <zhengyang@xxxxxxxxxxxxxx>
> > Signed-off-by: Heiko Stuebner <heiko@xxxxxxxxx>
> > Tested-by: Robin Murphy <robin.murphy@xxxxxxx>
>
> That reminds me, I really must dig out that box again and finish
> figuring out the GPIOs and regulators... :)
>
> [...]
> > +static int inno_hdmi_phy_probe(struct platform_device *pdev)
> > +{
> > + struct inno_hdmi_phy *inno;
> > + const struct of_device_id *match;
> > + struct phy_provider *phy_provider;
> > + struct resource *res;
> > + void __iomem *regs;
> > + int ret;
> > +
> > + inno = devm_kzalloc(&pdev->dev, sizeof(*inno), GFP_KERNEL);
> > + if (!inno)
> > + return -ENOMEM;
> > +
> > + inno->dev = &pdev->dev;
> > +
> > + match = of_match_device(inno->dev->driver->of_match_table, inno->dev);
> > + inno->plat_data = (struct inno_hdmi_phy_drv_data *)match->data;
>
> Nit: if there's cause to do another respin anyway, you could simplify
> this part with of_device_get_match_data().
done in v6 ... I found your mail directly after sending v5 ;-) .
