On 28/08/18 08:28, Leilk Liu wrote:
> This patch adds a DT binding documentation for the MT2712 soc.
>
> Signed-off-by: Leilk Liu <leilk.liu@xxxxxxxxxxxx>
> ---
> .../devicetree/bindings/spi/spi-slave-mt27xx.txt | 39 ++++++++++++++++++++
> 1 file changed, 39 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/spi/spi-slave-mt27xx.txt
Do I understand correctly that mt6xxx, mt7xxx and mt8xxx SoCs have a totally
different architecture then mt27xx so they will need a totally different
binding. If not, then please rename the binding description file and the driver.
Regards,
Matthias
>
> diff --git a/Documentation/devicetree/bindings/spi/spi-slave-mt27xx.txt b/Documentation/devicetree/bindings/spi/spi-slave-mt27xx.txt
> new file mode 100644
> index 0000000..dcb8934
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/spi/spi-slave-mt27xx.txt
> @@ -0,0 +1,39 @@
> +Binding for MTK SPI Slave controller
> +
> +Required properties:
> +- compatible: should be one of the following.
> + - mediatek,mt2712-spi: for mt2712 platforms
> +
> +- reg: Address and length of the register set for the device
> +
> +- interrupts: Should contain spi interrupt
> +
> +- clocks: phandles to input clocks.
> + The first should be one of the following. It's PLL.
> + - <&topckgen CLK_TOP_UNIVPLL1_D2>: specify parent clock 312MHZ.
> + It's the default one.
> + - <&topckgen CLK_TOP_UNIVPLL1_D4>: specify parent clock 156MHZ.
> + - <&topckgen CLK_TOP_UNIVPLL2_D4>: specify parent clock 104MHZ.
> + - <&topckgen CLK_TOP_UNIVPLL1_D8>: specify parent clock 78MHZ.
> + The second should be <&topckgen CLK_TOP_SPISLV_SEL>. It's clock mux.
> + The third is <&infracfg CLK_INFRA_AO_SPI1>. It's clock gate.
> +
> +- clock-names: shall be "parent-clk" for the parent clock, "sel-clk" for the
> + muxes clock, and "spi-clk" for the clock gate.
> +
> +- spi-slave: Empty property indicating the SPI controller is used in slave mode.
> +
> +Example:
> +
> +- SoC Specific Portion:
> +spis: spi@10013000 {
> + compatible = "mediatek,mt2712-spi-slave";
> + reg = <0 0x10013000 0 0x100>;
> + interrupts = <GIC_SPI 283 IRQ_TYPE_LEVEL_LOW>;
> + clocks = <&topckgen CLK_TOP_UNIVPLL1_D2>,
> + <&topckgen CLK_TOP_SPISLV_SEL>,
> + <&infracfg CLK_INFRA_AO_SPI1>;
> + clock-names = "parent-clk", "sel-clk", "spi-clk";
> + spi-slave;
> + status = "disabled";
> +};
>
