Re: [PATCH v2 25/40] mmc: sdhci: Add a quirk to disable card clock during tuning

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 10/08/18 21:08, Aapo Vienamo wrote:
> Add a quirk to disable card clock when the tuning command is sent.
> 
> This has to be done to prevent the SDHCI controller from hanging on
> Tegra210. Without the quirk enabled there appears to be around 10%
> chance that the tuning sequence will fail and time out due to the
> controller locking up.
> 
> Signed-off-by: Aapo Vienamo <avienamo@xxxxxxxxxx>
> ---
>  drivers/mmc/host/sdhci.c | 15 +++++++++++++++
>  drivers/mmc/host/sdhci.h |  2 ++
>  2 files changed, 17 insertions(+)
> 
> diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
> index 04dc443..166b16f 100644
> --- a/drivers/mmc/host/sdhci.c
> +++ b/drivers/mmc/host/sdhci.c
> @@ -2175,6 +2175,7 @@ static void sdhci_send_tuning(struct sdhci_host *host, u32 opcode)
>  	struct mmc_request mrq = {};
>  	unsigned long flags;
>  	u32 b = host->sdma_boundary;
> +	u16 clk;
>  
>  	spin_lock_irqsave(&host->lock, flags);
>  
> @@ -2183,6 +2184,13 @@ static void sdhci_send_tuning(struct sdhci_host *host, u32 opcode)
>  	cmd.mrq = &mrq;
>  
>  	mrq.cmd = &cmd;
> +
> +	if (host->quirks2 & SDHCI_QUIRK2_TUNE_DIS_CARD_CLK) {
> +		clk = sdhci_readw(host, SDHCI_CLOCK_CONTROL);
> +		clk &= ~SDHCI_CLOCK_CARD_EN;
> +		sdhci_writew(host, clk, SDHCI_CLOCK_CONTROL);

Rather than using a quirk, could you use the sdhci I/O accessors to disable
the clock before the tuning comment is written, udelay(1), and then enable
it again?

> +	}
> +
>  	/*
>  	 * In response to CMD19, the card sends 64 bytes of tuning
>  	 * block to the Host Controller. So we set the block size
> @@ -2213,6 +2221,13 @@ static void sdhci_send_tuning(struct sdhci_host *host, u32 opcode)
>  	mmiowb();
>  	spin_unlock_irqrestore(&host->lock, flags);
>  
> +	if (host->quirks2 & SDHCI_QUIRK2_TUNE_DIS_CARD_CLK) {
> +		udelay(1);
> +		clk = sdhci_readw(host, SDHCI_CLOCK_CONTROL);
> +		clk |= SDHCI_CLOCK_CARD_EN;
> +		sdhci_writew(host, clk, SDHCI_CLOCK_CONTROL);
> +	}
> +
>  	/* Wait for Buffer Read Ready interrupt */
>  	wait_event_timeout(host->buf_ready_int, (host->tuning_done == 1),
>  			   msecs_to_jiffies(50));
> diff --git a/drivers/mmc/host/sdhci.h b/drivers/mmc/host/sdhci.h
> index 0a99008..cc411b0 100644
> --- a/drivers/mmc/host/sdhci.h
> +++ b/drivers/mmc/host/sdhci.h
> @@ -452,6 +452,8 @@ struct sdhci_host {
>  #define SDHCI_QUIRK2_DISABLE_HW_TIMEOUT			(1<<17)
>  /* Don't clear the SDHCI_TRANSFER_MODE register on tuning commands */
>  #define SDHCI_QUIRK2_TUNE_SKIP_XFERMODE_REG_PROG	(1<<18)
> +/* Disable card clock during tuning */
> +#define SDHCI_QUIRK2_TUNE_DIS_CARD_CLK			(1<<19)
>  
>  	int irq;		/* Device IRQ */
>  	void __iomem *ioaddr;	/* Mapped address */
> 




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux