Signed-off-by: Maarten ter Huurne <maarten@xxxxxxxxxxxxxx>
Signed-off-by: Paul Cercueil <paul@xxxxxxxxxxxxxxx>
---
drivers/clocksource/Kconfig | 8 ++
drivers/clocksource/Makefile | 1 +
drivers/clocksource/ingenic-ost.c | 208
++++++++++++++++++++++++++++++++++++++
3 files changed, 217 insertions(+)
create mode 100644 drivers/clocksource/ingenic-ost.c
v5: New patch
v6: - Get rid of SoC IDs; pass pointer to ingenic_ost_soc_info as
devicetree match data instead.
- Use device_get_match_data() instead of the of_* variant
- Handle error of dev_get_regmap() properly
diff --git a/drivers/clocksource/Kconfig
b/drivers/clocksource/Kconfig
index 98f708208a8d..e855938c69f1 100644
--- a/drivers/clocksource/Kconfig
+++ b/drivers/clocksource/Kconfig
@@ -619,4 +619,12 @@ config INGENIC_TIMER
help
Support for the timer/counter unit of the Ingenic JZ SoCs.
+config INGENIC_OST
+ bool "Ingenic JZ47xx Operating System Timer"
+ depends on MIPS || COMPILE_TEST
+ depends on COMMON_CLK
+ select INGENIC_TIMER
+ help
+ Support for the OS Timer of the Ingenic JZ4770 or similar
SoC.
+
endmenu
diff --git a/drivers/clocksource/Makefile
b/drivers/clocksource/Makefile
index 26877505d400..56ce37252944 100644
--- a/drivers/clocksource/Makefile
+++ b/drivers/clocksource/Makefile
@@ -75,6 +75,7 @@ obj-$(CONFIG_ASM9260_TIMER) +=
asm9260_timer.o
obj-$(CONFIG_H8300_TMR8) += h8300_timer8.o
obj-$(CONFIG_H8300_TMR16) += h8300_timer16.o
obj-$(CONFIG_H8300_TPU) += h8300_tpu.o
+obj-$(CONFIG_INGENIC_OST) += ingenic-ost.o
obj-$(CONFIG_INGENIC_TIMER) += ingenic-timer.o
obj-$(CONFIG_CLKSRC_ST_LPC) += clksrc_st_lpc.o
obj-$(CONFIG_X86_NUMACHIP) += numachip.o
diff --git a/drivers/clocksource/ingenic-ost.c
b/drivers/clocksource/ingenic-ost.c
new file mode 100644
index 000000000000..400d30656790
--- /dev/null
+++ b/drivers/clocksource/ingenic-ost.c
@@ -0,0 +1,208 @@
+// SPDX-License-Identifier: GPL-2.0
+/*
+ * JZ47xx SoCs TCU Operating System Timer driver
+ *
+ * Copyright (C) 2016 Maarten ter Huurne <maarten@xxxxxxxxxxxxxx>
+ * Copyright (C) 2018 Paul Cercueil <paul@xxxxxxxxxxxxxxx>
+ */
+
+#include <linux/clk.h>
+#include <linux/clocksource.h>
+#include <linux/mfd/ingenic-tcu.h>
+#include <linux/module.h>
+#include <linux/platform_device.h>
+#include <linux/pm.h>
+#include <linux/regmap.h>
+#include <linux/sched_clock.h>
+
+#include "ingenic-timer.h"
+
+#define TCU_OST_TCSR_MASK 0xc0
+#define TCU_OST_TCSR_CNT_MD BIT(15)
+
+#define TCU_OST_CHANNEL 15
+
+struct ingenic_ost_soc_info {
+ bool is64bit;
+};
+
+struct ingenic_ost {
+ struct regmap *map;
+ struct clk *clk;
+
+ struct clocksource cs;
+};
+
+static u64 notrace ingenic_ost_read_cntl(void)
+{
+ /* Bypass the regmap here as we must return as soon as
possible */
+ return readl(ingenic_tcu_base + TCU_REG_OST_CNTL);
+}
+
+static u64 notrace ingenic_ost_read_cnth(void)
+{
+ /* Bypass the regmap here as we must return as soon as
possible */
+ return readl(ingenic_tcu_base + TCU_REG_OST_CNTH);
+}
+
+static u64 notrace ingenic_ost_clocksource_read(struct clocksource
*cs)
+{
+ u32 val1, val2;
+ u64 count, recount;
+ s64 diff;
+
+ /*
+ * The buffering of the upper 32 bits of the timer prevents
wrong
+ * results from the bottom 32 bits overflowing due to the
timer ticking
+ * along. However, it does not prevent wrong results from
simultaneous
+ * reads of the timer, which could reset the buffer
mid-read.
+ * Since this kind of wrong read can happen only when the
bottom bits
+ * overflow, there will be minutes between wrong reads, so
if we read
+ * twice in succession, at least one of the reads will be
correct.
+ */
+
+ /* Bypass the regmap here as we must return as soon as
possible */
+ val1 = readl(ingenic_tcu_base + TCU_REG_OST_CNTL);
+ val2 = readl(ingenic_tcu_base + TCU_REG_OST_CNTHBUF);
+ count = (u64)val1 | (u64)val2 << 32;
+
+ val1 = readl(ingenic_tcu_base + TCU_REG_OST_CNTL);
+ val2 = readl(ingenic_tcu_base + TCU_REG_OST_CNTHBUF);
+ recount = (u64)val1 | (u64)val2 << 32;
+
+ /*
+ * A wrong read will produce a result that is 1<<32 too
high: the bottom
+ * part from before overflow and the upper part from after
overflow.
+ * Therefore, the lower value of the two reads is the
correct value.
+ */
+
+ diff = (s64)(recount - count);
+ if (unlikely(diff < 0))
+ count = recount;
+
+ return count;
+}
+
+static int __init ingenic_ost_probe(struct platform_device *pdev)
+{
+ const struct ingenic_ost_soc_info *soc_info;
+ struct device *dev = &pdev->dev;
+ struct ingenic_ost *ost;
+ struct clocksource *cs;
+ unsigned long rate, flags;
+ int err;
+
+ soc_info = device_get_match_data(dev);
+ if (!soc_info)
+ return -EINVAL;
+
+ ost = devm_kzalloc(dev, sizeof(*ost), GFP_KERNEL);
+ if (!ost)
+ return -ENOMEM;
+
+ ost->map = dev_get_regmap(dev->parent, NULL);
+ if (!ost->map) {
+ dev_err(dev, "regmap not found\n");
+ return -EINVAL;
+ }
+
+ ost->clk = devm_clk_get(dev, "ost");
+ if (IS_ERR(ost->clk))
+ return PTR_ERR(ost->clk);
+
+ err = clk_prepare_enable(ost->clk);
+ if (err)
+ return err;
+
+ /* Clear counter high/low registers */
+ if (soc_info->is64bit)
+ regmap_write(ost->map, TCU_REG_OST_CNTL, 0);
+ regmap_write(ost->map, TCU_REG_OST_CNTH, 0);
+
+ /* Don't reset counter at compare value. */
+ regmap_update_bits(ost->map, TCU_REG_OST_TCSR,
+ TCU_OST_TCSR_MASK, TCU_OST_TCSR_CNT_MD);
+
+ rate = clk_get_rate(ost->clk);
+
+ /* Enable OST TCU channel */
+ regmap_write(ost->map, TCU_REG_TESR, BIT(TCU_OST_CHANNEL));
+
+ cs = &ost->cs;
+ cs->name = "ingenic-ost";
+ cs->rating = 320;
+ cs->flags = CLOCK_SOURCE_IS_CONTINUOUS;
+
+ if (soc_info->is64bit) {
+ cs->mask = CLOCKSOURCE_MASK(64);
+ cs->read = ingenic_ost_clocksource_read;
+ } else {
+ cs->mask = CLOCKSOURCE_MASK(32);
+ cs->read = (u64 (*)(struct clocksource
*))ingenic_ost_read_cnth;
+ }
+
+ err = clocksource_register_hz(cs, rate);
+ if (err) {
+ dev_err(dev, "clocksource registration failed:
%d\n", err);
+ clk_disable_unprepare(ost->clk);
+ return err;
+ }
+
+ /* Cannot register a sched_clock with interrupts on */
+ local_irq_save(flags);
+ if (soc_info->is64bit)
+ sched_clock_register(ingenic_ost_read_cntl, 32,
rate);
+ else
+ sched_clock_register(ingenic_ost_read_cnth, 32,
rate);
+ local_irq_restore(flags);
+
+ return 0;
+}
+
+#ifdef CONFIG_PM_SLEEP
+static int ingenic_ost_suspend(struct device *dev)
+{
+ struct ingenic_ost *ost = dev_get_drvdata(dev);
+
+ clk_disable(ost->clk);
+ return 0;
+}
+
+static int ingenic_ost_resume(struct device *dev)
+{
+ struct ingenic_ost *ost = dev_get_drvdata(dev);
+
+ return clk_enable(ost->clk);
+}
+
+static SIMPLE_DEV_PM_OPS(ingenic_ost_pm_ops, ingenic_ost_suspend,
+ ingenic_ost_resume);
+#define INGENIC_OST_PM_OPS (&ingenic_ost_pm_ops)
+#else
+#define INGENIC_OST_PM_OPS NULL
+#endif /* CONFIG_PM_SUSPEND */
+
+static const struct ingenic_ost_soc_info jz4725b_ost_soc_info = {
+ .is64bit = false,
+};
+
+static const struct ingenic_ost_soc_info jz4770_ost_soc_info = {
+ .is64bit = true,
+};
+
+static const struct of_device_id ingenic_ost_of_match[] = {
+ { .compatible = "ingenic,jz4725b-ost", .data =
&jz4725b_ost_soc_info, },
+ { .compatible = "ingenic,jz4770-ost", .data =
&jz4770_ost_soc_info, },
+ { }
+};
+MODULE_DEVICE_TABLE(of, ingenic_ost_of_match);
+
+static struct platform_driver ingenic_ost_driver = {
+ .probe = ingenic_ost_probe,
+ .driver = {
+ .name = "ingenic-ost",
+ .pm = INGENIC_OST_PM_OPS,
+ .of_match_table = ingenic_ost_of_match,
+ },
+};
+module_platform_driver(ingenic_ost_driver);
--
2.11.0