Nuvoton NPCM7XX I2C Controller
NPCM7xx includes 16 I2C contollers. This driver operates the controller.
This module also includes a slave mode, which will be submitted later on.
Any feedback would be appreciated.
v3 -> v2:
- fix dt binding: compatible name: ommit "bus"
v2 -> v1:
- run check patch in strict mode.
- use linux crc.
- define regs in constant offset without base.
- remove debug prints.
- no declerations for local functions.
v1: initial version
Signed-off-by: Tali Perry <tali.perry1@xxxxxxxxx>
---
.../devicetree/bindings/i2c/i2c-npcm7xx.txt | 29 ++++++++++++++++++++++
1 file changed, 29 insertions(+)
create mode 100644 Documentation/devicetree/bindings/i2c/i2c-npcm7xx.txt
diff --git a/Documentation/devicetree/bindings/i2c/i2c-npcm7xx.txt b/Documentation/devicetree/bindings/i2c/i2c-npcm7xx.txt
new file mode 100644
index 000000000000..2a474a2a5b3f
--- /dev/null
+++ b/Documentation/devicetree/bindings/i2c/i2c-npcm7xx.txt
@@ -0,0 +1,29 @@
+Nuvoton NPCM7XX I2C bus
+
+The NPCM750x includes sixteen I2C bus controllers. All Conterollers support
+both master and slave mode. Each controller has two 16 byte HW FIFO for TX and
+RX.
+
+Required properties:
+- compatible : must be "nuvoton,npcm750-i2c"
+- reg : Offset and length of the register set for the device.
+- interrupts : Contain the I2C interrupt with flags for falling edge.
+- clocks : phandle of I2C reference clock.
+
+Optional:
+- bus-frequency : Contain the I2C bus frequency,
+ the default I2C bus frequency is 100000.
+- pinctrl-0 : must be <&smbX_pins>, X is module number
+ (on NPCM7XX it's 0 to 15)
+- pinctrl-names : should be set to "default"
+Example:
+
+ i2c0: i2c@80000 {
+ compatible = "nuvoton,npcm750-i2c";
+ reg = <0x80000 0x1000>;
+ clocks = <&clk NPCM7XX_CLK_APB2>;
+ bus-frequency = <100000>;
+ interrupts = <GIC_SPI 64 IRQ_TYPE_LEVEL_HIGH>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&smb0_pins>;
+ };
--
2.14.1
