On 31/07/2018 17:17:47+0300, Andy Shevchenko wrote: > On Tue, 2018-07-31 at 15:47 +0200, Alexandre Belloni wrote: > > Hi, > > > > Because the designware IP was not able to handle the SDA hold time > > before > > version 1.11a, MSCC has its own implementation. Add support for it and > > then add > > i2c on ocelot boards. > > > > I would expect patches 1 to 4 to go through the i2c tree and 5-6 > > through > > the mips tree once patch 4 has been reviewed by the DT maintainers. > > > > Thanks for an update, looks quite nice! > I gave my tags wherever it is appropriate. > > > Changes in v2: > > - removed first patch as a similar one is in i2c-next > > > - rebase on top of i2c-next > > It seems you also took my patches which are not yet in i2c/for-next. > That is right, I also based on https://patchwork.ozlabs.org/project/linux-i2c/list/?series=57551 but it is not a hard dependency. > > - Added two patches to implement ideas from Andy > > > > Alexandre Belloni (6): > > i2c: designware: use generic table matching > > i2c: designware: move #ifdef CONFIG_OF to the top > > i2c: designware: allow IP specific sda_hold_time > > i2c: designware: add MSCC Ocelot support > > mips: dts: mscc: Add i2c on ocelot > > mips: dts: mscc: enable i2c on ocelot_pcb123 > > > > .../bindings/i2c/i2c-designware.txt | 9 ++- > > arch/mips/boot/dts/mscc/ocelot.dtsi | 18 ++++++ > > arch/mips/boot/dts/mscc/ocelot_pcb123.dts | 6 ++ > > drivers/i2c/busses/i2c-designware-common.c | 2 + > > drivers/i2c/busses/i2c-designware-core.h | 4 ++ > > drivers/i2c/busses/i2c-designware-platdrv.c | 62 +++++++++++++++--- > > - > > 6 files changed, 87 insertions(+), 14 deletions(-) > > > > -- > Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx> > Intel Finland Oy -- Alexandre Belloni, Bootlin (formerly Free Electrons) Embedded Linux and Kernel engineering https://bootlin.com -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
