Hi,
On Sun, Jul 22, 2018 at 06:35:58PM +0200, Saravanan Sekar wrote:
> pad control for s900 and s700 are differs in number of
> pull control configuraions
> s900 has 4 pull controls - high impedence, pull up, pull down, repeater
> s700, s500 has 2 pull controls - pull up and pull down
>
You should clearly mention what the commit is actually doing.
> Signed-off-by: Parthiban Nallathambi <pn@xxxxxxx>
> Signed-off-by: Saravanan Sekar <sravanhome@xxxxxxxxx>
> ---
> drivers/pinctrl/actions/pinctrl-owl.c | 64 ++++---------------------
> drivers/pinctrl/actions/pinctrl-owl.h | 13 +++--
> drivers/pinctrl/actions/pinctrl-s900.c | 66 +++++++++++++++++++++++++-
> 3 files changed, 79 insertions(+), 64 deletions(-)
>
> diff --git a/drivers/pinctrl/actions/pinctrl-owl.c b/drivers/pinctrl/actions/pinctrl-owl.c
> index b5c880b50bb3..f72da7aae4ff 100644
> --- a/drivers/pinctrl/actions/pinctrl-owl.c
> +++ b/drivers/pinctrl/actions/pinctrl-owl.c
> @@ -242,60 +242,6 @@ static int owl_pad_pinconf_reg(const struct owl_padinfo *info,
> return 0;
> }
>
> -static int owl_pad_pinconf_arg2val(const struct owl_padinfo *info,
> - unsigned int param,
> - u32 *arg)
> -{
> - switch (param) {
> - case PIN_CONFIG_BIAS_BUS_HOLD:
> - *arg = OWL_PINCONF_PULL_HOLD;
> - break;
> - case PIN_CONFIG_BIAS_HIGH_IMPEDANCE:
> - *arg = OWL_PINCONF_PULL_HIZ;
> - break;
> - case PIN_CONFIG_BIAS_PULL_DOWN:
> - *arg = OWL_PINCONF_PULL_DOWN;
> - break;
> - case PIN_CONFIG_BIAS_PULL_UP:
> - *arg = OWL_PINCONF_PULL_UP;
> - break;
> - case PIN_CONFIG_INPUT_SCHMITT_ENABLE:
> - *arg = (*arg >= 1 ? 1 : 0);
> - break;
> - default:
> - return -ENOTSUPP;
> - }
> -
> - return 0;
> -}
> -
> -static int owl_pad_pinconf_val2arg(const struct owl_padinfo *padinfo,
> - unsigned int param,
> - u32 *arg)
> -{
> - switch (param) {
> - case PIN_CONFIG_BIAS_BUS_HOLD:
> - *arg = *arg == OWL_PINCONF_PULL_HOLD;
> - break;
> - case PIN_CONFIG_BIAS_HIGH_IMPEDANCE:
> - *arg = *arg == OWL_PINCONF_PULL_HIZ;
> - break;
> - case PIN_CONFIG_BIAS_PULL_DOWN:
> - *arg = *arg == OWL_PINCONF_PULL_DOWN;
> - break;
> - case PIN_CONFIG_BIAS_PULL_UP:
> - *arg = *arg == OWL_PINCONF_PULL_UP;
> - break;
> - case PIN_CONFIG_INPUT_SCHMITT_ENABLE:
> - *arg = *arg == 1;
> - break;
> - default:
> - return -ENOTSUPP;
> - }
> -
> - return 0;
> -}
> -
> static int owl_pin_config_get(struct pinctrl_dev *pctrldev,
> unsigned int pin,
> unsigned long *config)
> @@ -314,7 +260,10 @@ static int owl_pin_config_get(struct pinctrl_dev *pctrldev,
>
> arg = owl_read_field(pctrl, reg, bit, width);
>
> - ret = owl_pad_pinconf_val2arg(info, param, &arg);
> + if (!pctrl->soc->padctl_val2arg)
> + return -ENOTSUPP;
> +
> + ret = pctrl->soc->padctl_val2arg(info, param, &arg);
> if (ret)
> return ret;
>
> @@ -345,7 +294,10 @@ static int owl_pin_config_set(struct pinctrl_dev *pctrldev,
> if (ret)
> return ret;
>
> - ret = owl_pad_pinconf_arg2val(info, param, &arg);
> + if (!pctrl->soc->padctl_arg2val)
> + return -ENOTSUPP;
> +
> + ret = pctrl->soc->padctl_arg2val(info, param, &arg);
> if (ret)
> return ret;
>
> diff --git a/drivers/pinctrl/actions/pinctrl-owl.h b/drivers/pinctrl/actions/pinctrl-owl.h
> index 42635366e68f..669591c5400e 100644
> --- a/drivers/pinctrl/actions/pinctrl-owl.h
> +++ b/drivers/pinctrl/actions/pinctrl-owl.h
> @@ -139,13 +139,6 @@
> .st = &name##_st_conf, \
> }
>
> -enum owl_pinconf_pull {
> - OWL_PINCONF_PULL_HIZ,
> - OWL_PINCONF_PULL_DOWN,
> - OWL_PINCONF_PULL_UP,
> - OWL_PINCONF_PULL_HOLD,
> -};
> -
Why can't this be left here itself?
> enum owl_pinconf_drv {
> OWL_PINCONF_DRV_2MA,
> OWL_PINCONF_DRV_4MA,
> @@ -278,6 +271,12 @@ struct owl_pinctrl_soc_data {
> unsigned int ngpios;
> const struct owl_gpio_port *ports;
> unsigned int nports;
> + int (*padctl_val2arg)(const struct owl_padinfo *padinfo,
> + unsigned int param,
> + u32 *arg);
> + int (*padctl_arg2val)(const struct owl_padinfo *info,
> + unsigned int param,
> + u32 *arg);
> };
>
> int owl_pinctrl_probe(struct platform_device *pdev,
> diff --git a/drivers/pinctrl/actions/pinctrl-s900.c b/drivers/pinctrl/actions/pinctrl-s900.c
> index baa2f4847418..dc7bdc1f5cde 100644
> --- a/drivers/pinctrl/actions/pinctrl-s900.c
> +++ b/drivers/pinctrl/actions/pinctrl-s900.c
> @@ -13,6 +13,7 @@
> #include <linux/of.h>
> #include <linux/platform_device.h>
> #include <linux/pinctrl/pinctrl.h>
> +#include <linux/pinctrl/pinconf-generic.h>
> #include "pinctrl-owl.h"
>
> /* Pinctrl registers offset */
> @@ -1717,6 +1718,67 @@ static const struct owl_gpio_port s900_gpio_ports[] = {
> OWL_GPIO_PORT(F, 0x00F0, 8, 0x0, 0x4, 0x8)
> };
>
> +enum owl_pinconf_pull {
> + OWL_PINCONF_PULL_HIZ,
> + OWL_PINCONF_PULL_DOWN,
> + OWL_PINCONF_PULL_UP,
> + OWL_PINCONF_PULL_HOLD,
> +};
> +
> +static int owl_pad_pinconf_s900_arg2val(const struct owl_padinfo *info,
> + unsigned int param,
> + u32 *arg)
How about s900_pad_pinconf_arg2val?
> +{
> + switch (param) {
> + case PIN_CONFIG_BIAS_BUS_HOLD:
> + *arg = OWL_PINCONF_PULL_HOLD;
> + break;
> + case PIN_CONFIG_BIAS_HIGH_IMPEDANCE:
> + *arg = OWL_PINCONF_PULL_HIZ;
> + break;
> + case PIN_CONFIG_BIAS_PULL_DOWN:
> + *arg = OWL_PINCONF_PULL_DOWN;
> + break;
> + case PIN_CONFIG_BIAS_PULL_UP:
> + *arg = OWL_PINCONF_PULL_UP;
> + break;
> + case PIN_CONFIG_INPUT_SCHMITT_ENABLE:
> + *arg = (*arg >= 1 ? 1 : 0);
> + break;
> + default:
> + return -ENOTSUPP;
> + }
> +
> + return 0;
> +}
> +
> +static int owl_pad_pinconf_s900_val2arg(const struct owl_padinfo *padinfo,
> + unsigned int param,
> + u32 *arg)
How about s900_pad_pinconf_val2arg?
Thanks,
Mani
> +{
> + switch (param) {
> + case PIN_CONFIG_BIAS_BUS_HOLD:
> + *arg = *arg == OWL_PINCONF_PULL_HOLD;
> + break;
> + case PIN_CONFIG_BIAS_HIGH_IMPEDANCE:
> + *arg = *arg == OWL_PINCONF_PULL_HIZ;
> + break;
> + case PIN_CONFIG_BIAS_PULL_DOWN:
> + *arg = *arg == OWL_PINCONF_PULL_DOWN;
> + break;
> + case PIN_CONFIG_BIAS_PULL_UP:
> + *arg = *arg == OWL_PINCONF_PULL_UP;
> + break;
> + case PIN_CONFIG_INPUT_SCHMITT_ENABLE:
> + *arg = *arg == 1;
> + break;
> + default:
> + return -ENOTSUPP;
> + }
> +
> + return 0;
> +}
> +
> static struct owl_pinctrl_soc_data s900_pinctrl_data = {
> .padinfo = s900_padinfo,
> .pins = (const struct pinctrl_pin_desc *)s900_pads,
> @@ -1727,7 +1789,9 @@ static struct owl_pinctrl_soc_data s900_pinctrl_data = {
> .ngroups = ARRAY_SIZE(s900_groups),
> .ngpios = NUM_GPIOS,
> .ports = s900_gpio_ports,
> - .nports = ARRAY_SIZE(s900_gpio_ports)
> + .nports = ARRAY_SIZE(s900_gpio_ports),
> + .padctl_arg2val = owl_pad_pinconf_s900_arg2val,
> + .padctl_val2arg = owl_pad_pinconf_s900_val2arg,
> };
>
> static int s900_pinctrl_probe(struct platform_device *pdev)
> --
> 2.18.0
>
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
