Implement polling with 10 ms timeout for automatic pad drive strength
calibration.
Signed-off-by: Aapo Vienamo <avienamo@xxxxxxxxxx>
---
drivers/mmc/host/sdhci-tegra.c | 21 ++++++++++++++++-----
1 file changed, 16 insertions(+), 5 deletions(-)
diff --git a/drivers/mmc/host/sdhci-tegra.c b/drivers/mmc/host/sdhci-tegra.c
index 9587365..27b5ef9 100644
--- a/drivers/mmc/host/sdhci-tegra.c
+++ b/drivers/mmc/host/sdhci-tegra.c
@@ -16,6 +16,7 @@
#include <linux/err.h>
#include <linux/module.h>
#include <linux/init.h>
+#include <linux/iopoll.h>
#include <linux/platform_device.h>
#include <linux/clk.h>
#include <linux/io.h>
@@ -49,6 +50,9 @@
#define SDHCI_AUTO_CAL_START BIT(31)
#define SDHCI_AUTO_CAL_ENABLE BIT(29)
+#define SDHCI_TEGRA_AUTO_CAL_STATUS 0x1ec
+#define SDHCI_TEGRA_AUTO_CAL_ACTIVE BIT(31)
+
#define NVQUIRK_FORCE_SDHCI_SPEC_200 BIT(0)
#define NVQUIRK_ENABLE_BLOCK_GAP_DET BIT(1)
#define NVQUIRK_ENABLE_SDHCI_SPEC_300 BIT(2)
@@ -229,13 +233,20 @@ static void tegra_sdhci_reset(struct sdhci_host *host, u8 mask)
static void tegra_sdhci_pad_autocalib(struct sdhci_host *host)
{
- u32 val;
+ u32 reg;
+ int ret;
+
+ reg = sdhci_readl(host, SDHCI_TEGRA_AUTO_CAL_CONFIG);
+ reg |= SDHCI_AUTO_CAL_ENABLE | SDHCI_AUTO_CAL_START;
+ sdhci_writel(host, reg, SDHCI_TEGRA_AUTO_CAL_CONFIG);
- mdelay(1);
+ /* 10 ms timeout */
+ ret = readl_poll_timeout(host->ioaddr + SDHCI_TEGRA_AUTO_CAL_STATUS,
+ reg, !(reg & SDHCI_TEGRA_AUTO_CAL_ACTIVE),
+ 1, 10000);
- val = sdhci_readl(host, SDHCI_TEGRA_AUTO_CAL_CONFIG);
- val |= SDHCI_AUTO_CAL_ENABLE | SDHCI_AUTO_CAL_START;
- sdhci_writel(host,val, SDHCI_TEGRA_AUTO_CAL_CONFIG);
+ if (ret)
+ dev_err(mmc_dev(host->mmc), "Pad autocal timed out\n");
}
static void tegra_sdhci_set_clock(struct sdhci_host *host, unsigned int clock)
--
2.7.4
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
