On 17/07/2018 15:21:20+0300, Andy Shevchenko wrote: > On Tue, 2018-07-17 at 13:48 +0200, Alexandre Belloni wrote: > > Hi, > > > > Because the designware IP was not able to the the SDA hold time, MSCC > > has > > its own implementation. Add support for it and then add i2c on ocelot > > boards. > > > > I would expect patches 1 to 3 to go through the i2c tree and 4-5 > > through > > the mips tree once patch 3 has been reviewed by the DT maintainers. > > Without reading datasheet it all feels like a wrong place to put. > > But maybe that SoC (SoC family?) has some update to DesignWare IP. > Btw, what the version of DW IP it's using? 2.00a? More older, more > recent? > COMP_VERSION reads 0x3131302A so it is before DW_IC_SDA_HOLD_MIN_VERS. > > > Alexandre Belloni (5): > > i2c: designware: factorize setting SDA hold time > > i2c: designware: allow IP specific sda_hold_time > > i2c: designware: add MSCC Ocelot support > > mips: dts: mscc: Add i2c on ocelot > > mips: dts: mscc: enable i2c on ocelot_pcb123 > > > > .../bindings/i2c/i2c-designware.txt | 5 ++- > > arch/mips/boot/dts/mscc/ocelot.dtsi | 19 +++++++++++ > > arch/mips/boot/dts/mscc/ocelot_pcb123.dts | 5 +++ > > drivers/i2c/busses/i2c-designware-common.c | 33 > > +++++++++++++++++++ > > drivers/i2c/busses/i2c-designware-core.h | 3 ++ > > drivers/i2c/busses/i2c-designware-master.c | 22 +------------ > > drivers/i2c/busses/i2c-designware-platdrv.c | 20 +++++++++++ > > drivers/i2c/busses/i2c-designware-slave.c | 22 +------------ > > 8 files changed, 86 insertions(+), 43 deletions(-) > > > > -- > Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx> > Intel Finland Oy -- Alexandre Belloni, Bootlin (formerly Free Electrons) Embedded Linux and Kernel engineering https://bootlin.com -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html